How do i reset service engine soon light on 2000 suzuki grand vitara

Anand Kumar

• 2035 Answers
• Posted on Jul 15, 2008

SOURCE: suzuki grand vitara 2.0 TDI

This could the problem with onboard computer failure .......

try that after visual check under hood confirms no obvious failures like missing drive belt or disconnected electric wires...

Please mention make code and year of the peugeot engine in the car.....

Good luck....

SOURCE: where is the starter for a 2000 suzuki grand vitara located

starters are normally located at the rear of the motor usually hard to get too or see. should be on your bell housing in other words just in front of the gearbox/clutch

SOURCE: service engine soon light grand vitara xl-7 on

You know I would doubt that this is caused by a speed wristed attendant, especially if you have removed and replaced the gas cap at the correct speed and the light stays on. ..................... ha ha.

Seems to be a recurring problem and having just spent a poop load of money with 2 dealers on that SES light issue I will tell you that the 2001 2.7 V6 engines have 4 O2 sensors and 3 catalytic converters. According to both dealers as those aforementioned parts approach the 100,000 mile marker they tend to send error codes. You get the errors cleared and 50 miles later there is the SES light again. The O2 sensors seemd to be very difficult to remove, both shops indicated you are better off to buy new catalytic converters, install new O2 sensors in them and then bolt in the whole mess as a unit. This of course assumes your bad readings are O2 sensor related. I would take it to a dealer as oppsed to autozone or advance as their generic little readers pale in comparison to the code readers at the dealership. price reflects that though.

SOURCE: 2002 Grand Vitara engine light

Try these easy things...take off clean and reconnect the battery cables, take to Auto Zone for a FREE computer hook up. More than likely if the battery hook up doesn't work it's the oxygen sensor.

ZJ Limited

• 17989 Answers
• Posted on May 15, 2010

SOURCE: How to change the fuel filter on a suzuki grand Vitara

Fuel FIlter - Removal

1. Relieve fuel system pressure.
2. Remove or disconnect the following:
   Negative battery cable Fuel lines from the fuel filter Fuel filter
   

1. Install or connect the following:
   Fuel filter and tighten the bracket bolt. Note the fuel flow directional arrow. Fuel lines to the fuel filter. Negative battery cable
2. Start the engine and inspect the fuel filter connections for leaks.
   

1. Before servicing the vehicle, refer to the Precautions section.
2. Relieve fuel system pressure.
3. Remove or disconnect the following:
   Negative battery cable Fuel lines from the fuel filter Fuel filter
   

1. Install or connect the following:
   Fuel filter and tighten the bracket bolt. Note the fuel flow directional arrow. Fuel lines to the fuel filter. Negative battery cable
2. Start the engine and inspect the fuel filter connections for leaks.