SOURCE: How to install the front license plate on the 2008
There should be guide holes in the bumper for you to mount the plate. It's recommended to mount a backing piece and then mount the place onto the backing for sturdiness. If there are no holes, you can just screw two holes into the bumper
SOURCE: 1990 jeep wrangler rear end "bang" noise then jeep would move,
I had the same thing happen. Your rear drive shaft u-jount is bad. Also wnat to check the level of gear oil...
Replacing the u-joint takes about an hour to do... not a tough job.
SOURCE: location of cabin air filter
It can have a cabin air filter, but most vehicles ship without it.
Either way, you can access the cabin air filter housing by opening the glove box all the way (squeeze the sides so it clears the stops).
The filters are around $15 at the dealer.
Whether or not there's a cabin filter installed, make sure you're also
following Chrysler's recommendations in the owner's manual—running the
air on recirculate all the time will encourage mold and bacteria to
grow.
Good luck
SOURCE: Truck has a humming noise from the rear end which
Sounds like the rear end itself, most likely if u have high mileage.
Testimonial: "That is absolutely my thoughts as well.I was hoping not to hear that, but was expecting that. It has 215k on the drivetrain, so I guess it is time for replacement. This is my first 4 wheel drive, so I am learning as I go. Thank you for your time and insight. Just have to find an affordable place in DFW to get the gears."
SOURCE: how do you reset change
1. Turn the ignition switch to the ON position (Do not
start the engine).
2. Fully depress the accelerator pedal slowly three times
within 10 seconds.
3. Turn the ignition switch to the OFF/LOCK position.
NOTE: If the indicator message illuminates when you
start the vehicle, the oil change indicator system did not
reset. If necessary repeat this procedure."
Follow these instructions.
276 views
Usually answered in minutes!
×