SOURCE: 2005 ford escape assembly diagram for the front axle
If they are sealed bearings, you will need a press to get them out. If they are bolt in, just remove the brake pads/rotors, then the axle nut, then the bolts holding the wheel bearing in. Install in reverse order.
SOURCE: Brake drum 2005 Escape
here is a diagram on how to remove your brake drum. please do not forget to rate and comment about your experience with fixya today.
Removal & Installation
CAUTION
Dust and dirt accumulating on brake parts during normal use may contain asbestos fibers from production or aftermarket brake linings. Breathing excessive concentrations of asbestos fibers can cause serious bodily harm. Exercise care when servicing brake parts. Do not sand or grind brake lining unless equipment used is designed to contain the dust residue. Do not clean brake parts with compressed air or by dry brushing. Cleaning should be done by dampening the brake components with a fine mist of water, then wiping the brake components clean with a dampened cloth. Dispose of cloth and all residue containing asbestos fibers in an impermeable container with the appropriate label. Follow practices prescribed by the Occupational Safety and Health Administration (OSHA) and the Environmental Protection Agency (EPA) for the handling, processing, and disposing of dust or debris that may contain asbestos fibers.
To install:
CAUTION
Use of a brake drum puller or a torch is not recommended. Brake drum distortion can result.
NOTE
If the brake drum is rusted to the axle shaft pilot diameter, tap the center of the brake drum between the wheel studs.
Drum brake exploded view
WARNING
Whenever a wheel is installed, always remove any corrosion, dirt or foreign material present on the mounting surfaces of the wheel or the surface of the wheel hub, brake drum or brake disc that contacts the wheel. Installing wheels without correct metal-to-metal contact at the wheel mounting surfaces can cause the wheel nuts to loosen and the wheel to come off while the vehicle is in motion, causing loss of control. Failure to follow these instructions may result in personal injury.
SOURCE: Need to replace headlight assembly on 2005 Ford Escape
ithere are 4 bolts that hold it in...the top 2 are obvious..the others are behind the bumper. the bumper must be removed to acces them...here are the manuals instructions..
Item
Part Number
Description
1
—
Headlamp assembly bolts (3 required)
2
—
Headlamp assembly nut
3
13008
Headlamp assembly
4
14290
Electrical connectors
Removal and Installation
NOTE: Make sure the headlamp switch and the ignition switch are in the OFF position.
SOURCE: how to replace the power window switch on a 2005
just a standard screwdriver...
on the inside trim, you can remove screws that are by the door handle,
arm rest, under door and side of door and then gently pull back on the
panel as there will also be retaining clips attached and you don't want
to break them. You'll need to lift the door panel upwards in order to
get it off the window ledge.
SOURCE: tool to remove front brake caliper to replace rotor Escape 2005
You need a 7mm socket, which are available at auto parts stores.
89 views
Usually answered in minutes!
×