2000 Pontiac Bonneville Logo
Anonymous Posted on Oct 05, 2014

Why would the #5 injector and #6 injector not work,i replaced both and now #3 and #6 dont work?

The problem started when the car ran out of gas,i replaced the fuel pump and filter,also replaced plugs and wires. I checked the ohms on the injectors which was 12.7.I can take the wire off the #3 and #6 with no engine miss. I also replaced the cam sensor.

1 Answer

Denis Houle

Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

  • Pontiac Master 1,414 Answers
  • Posted on Jan 19, 2015
Denis Houle
Pontiac Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Joined: Aug 02, 2013
Answers
1414
Questions
0
Helped
498563
Points
4096

You need special Tools for injector balance test and anoid lights to test wiring to injectors
hope it help

5 Related Answers

Anonymous

  • 99 Answers
  • Posted on Nov 30, 2008

SOURCE: Fuel Injector Wont Spray

check wires at throttle body. can use a 12 volt test light to check for current. if you have spark it is not the ign module. set meter for 12-20volts. should have 2 fuse boxes on this model, one behind right side of dash at floorboard

Ad

Anonymous

  • 67 Answers
  • Posted on Apr 10, 2009

SOURCE: 1994 pontiac bonneville fires up but stalls imediatly

WOW a 94 with 46K on it thats rare. Your computer may be bad it sends the pulse to the injector.

Hector L. Morales

  • 649 Answers
  • Posted on Aug 02, 2009

SOURCE: 1990 Pontiac grand prix bogs down, and wants to

Have you checked the ignition module? More info such as eng size would be helpful to help you.

cheap repair

  • 1565 Answers
  • Posted on Oct 12, 2010

SOURCE: My 1995 Pontiac Bonneville will

crank position sensor...if the engine will start and run for a second or two then it dies. If, however, you can press and hold the gas pedal slightly and keep the engine going, then I would suspect the IAC-idle air control valve. This can be cleaned with spray carb cleaner.

stevexmas007

Steve Christmas

  • 699 Answers
  • Posted on Apr 09, 2011

SOURCE: Trying to work on my

Where i would start with the injectors shorting out may have shorted out your ecm " computer" This will cause Everything you listed. You can reset just need to contact dealer and find out you reset on this kind of vechical.But i would guess it's fryed with all the short's , Best of luck to you. I i can help any futher just ask, I'll do my best.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
1answer

Where is the fuel injector relay on a 2004 vw gti 2.8 liter 24 valve 6 cylinder?

check the immobilizer as it may be preventing the ECM to allow fuel past the injectors
run the fault codes and it could be the ECM needs resetting using a scan tool
1helpful
1answer

No fuel comeing out of injectorson carb

may i know the year and type of the vehicle
0helpful
1answer

When i checked the # 3 and # 6 injector they were not working, i replaced both with used injectors and now the #5 and #6 are not working?

what about the ignition coil or crankshaft sensor. with h.e.i spark tester you will find the defect coil

hope it helps
0helpful
1answer

I have a 2006 Dodge ram diesal It acts like it ran out of gas thing is it just died It wasn't the gas I think it might be the brain so how could I don't troubleshooter It

Firstly dont talk and drive as you lose concentration and spill your drink,saciledge .Right 2006 diesel so its common rail ,now first thing to do is get the multimeter out and check you have a pulse to a injector when cranking the engine ,then work from their so if you have a pulse to a injector then its fuel ,now in the tank is a low pressure lift pump which supplies fuel when starting but lots of vehicles dont run this pump all the time ,now iam not familar with this american vehicle as to layout but at the end of the day its a diesel which i do most of my work on here in spain ,anything with more than 3 cylinders has to be a diesel here owing the price of fuel ,right check for a pulse first then slacken a diesel fuel pipe to one of the injectors and see if you have fuel pressure ,then post your findings and we will work out where to hit it and with size hammer that will fix it
0helpful
1answer

My car wont start engine turns over but doesnt start like ist recieving no gas

Considering it ran fine after pump replacement for awhile then it is probably a fuel issue. Couple things it could be. 1. you could have a ton of sediment in gas tank and it keeps clogging up your pump. 2. you could have blocked fuel filter and or clogged injectors.
0helpful
1answer

Ran out of gas now car dont stay on

If you ran the tank dry you've lost pressure between the pump and the injectors. You'll need to prime the fuel pump.
0helpful
3answers

Dont know

check your fuel filter and make sure it not plugged up, make sure you reinstall exactly as it came off.
good luck
0helpful
4answers

1989 Pontiac 6000 LE

Check AutoZone.com as they have an area where they can tell you where the parts are located on your car.
Not finding what you are looking for?

99 views

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...