SOURCE: 2006 mercury mariner. stupid tail light assembly.
they are hard to take off sometimes, you are doing it right just keep willing it it will come off, there is 2 gromits that hold it into place might have a little dirt into the plunger.
SOURCE: what tool do i need to replace front brake pads on 2008 mariner?
You Will Need A 13-14 mm Wrench for Caliper Bolts .A Large Flathead Screwdriver to Spred open Caliper/Shoes to Remove Caliper from Rotor,
After rhis you Can use a LARGE "C" Clamp to CLOSE Caliper Piston.
SOURCE: Service brake system light and
To have both of those errors at once it is more than likely a speed sensor error. A shop can use a diagnosic tool to indicate if so, and which wheel it is, then try to clean it, check connections, or replace it.
SOURCE: 06 Mercury Mariner...ABS light comes
HAVE VECHICLE CODE SCAN.SOUND LIKE YOU COULD HAVE BAD WHEEL SENSOR OR DISCONNECTED OR LOOSE WIRE.BECAUSE 4WD DRIVE NEEDS SIGNALS FROM WHEEL SPEED SENSORS AND VECHICLE SPEED SENSOR BEFORE AUTOMATIC TRANSMISSION AND TRANSFER CASE CAN SHIFT CORRECTLY.
SOURCE: Need to obtain master keypad code for 2008 mercury
Pry up the chrome ring around the shifter.
Lift up the console lid and pull out the black container.
Pull up the center console from the cup holder end, it is held down with snap in clips.
The code is on the top-right corner of a white sticker upside down.
More Info: http://www.escape-central.com/1forum/showthread.php?threadid=31595
1,161 views
Usually answered in minutes!
×