SOURCE: my 93 lexus es 300 transmission will not shift
if it has cables for your shifter xheck them they break.im assuming its an standard
SOURCE: Location of Shift Solenoid in 1999 Ford Expedition Eddie Bauer?
They are round "cans" with wires attached. You should have SSA, SSB, SSC, Torque converter and Pressure Control solenoids. They control pressures and have no mechanical linkage.
SOURCE: speedometer does not work. Transmission shifts
The vehile speed sensor is mounted on the transmission and has a two-wire connector going to it.
SOURCE: i have a 2005 ford focus and am having transmission shift problem
No movement in any gear: pump failure, R&R, To check for pump failure, check fluid level with the engine off, then start the engine and recheck fluid level. If level does not go down when engine is running, the pump is broken.
Front pump bushing walked out. R&R. May have to replace converter also if hub is scored. Note that a leaking front seal usually means the bushing is walking out (i.e. call your local trans shop and schedule an appt.).
Loud bang, grinding sound, loss of all gears, and a binding driveshaft: snapped output shaft. Try to wiggle two end driveshaft (inner CV joint) - if more than 0.020" play, that's the sign. R&R.
These are just some of the things that could have happened to your transmission, regardless your going to have to have it sent in to a transmission shop for a repair, and grinding noise indicate a hard part is broken and not electrical issues.
Try not to run the engine or move the car or further damage could result. Good luck and thank you for using Fixya
SOURCE: My 2005 dodge grand caravan is having a shifting
is the "CHECK ENGINE " light on?
what code.?
58 views
Usually answered in minutes!
×