How to take an motor out of an 1976 Minnie Winnebago
You need to take off the bumper and the door that covers engine access. You'll need a low boy engine hoist. Take out the radiator and push aside the AC condenser and oil cooler. Take off the fan blades from the watre pump pulley. Find a good place to hook up the chain on the hoist. Now go under the engine and remove the access cover on the bell housing. Take out the bolts that hold the torque converter to the flywheel. Now go after the bolts that hold the transmission to the engine. Put a floor jack under the transmission so it wont drop when you jack up the engine with the hoist. After you remove all the electrical wiring from the components on the engine remove the bolts on the motor mounts and raise the engine with the hoist . Pull the engine out while looking for anything that you didn't disconnect. Be sure the transmission doesn't drop when the engine separates from it.
SOURCE: need schematic for 1976 dodge
If you are looking for a complete electrical schematic for this vehicle i think its gonna take alot more than FIxYa. I had a pace arrow 1984 and o boy, if it wasnt for some knowledge and hands on even looking at a schematic it was almost impossible to figure out. wires and switches everywhere, i might try to contact chrysler or find the builder of this and see if you can get such paperwork, i wish you the best.
134 views
Usually answered in minutes!
×