SOURCE: 2000 ford contour
this is what you have to do you have to have a bar across the top of the engine with a chain so the engine does not fall down you also have to remove the axel on the driver side making sure you have jack stands and the car supported for safety but you can also go to auto zone and have them to print you a step by step diagram
SOURCE: Fuel injector cut off switch for 1999 ford contour se
Try looking by your left foot, while sitting in the drivers seat.
SOURCE: WIRING DIAGRAM A/C SYSTEM ON A 1999 FORD CONTOUR,2.0L ENGINE
Haynes Manuals not Chiltons are the source I use for wiring. You local library might have one and photocopy it off.
SOURCE: 1999 ford contour that wont crank
You mean wont CRANK or CRANKS but WONT RUN???? 4 cyl or V6 auto or manual trans????????? The 8th VIN digit would be most helpful as there are 4 different engines for that car. Its really cheaper to check items before you replace them. The starter should have a smaller BLACK wire that should have power on it when trying to crank the car. You say it wont crank, then check the neutral switch on the trans. Try putting it in neutral to start it. If it has a manual trans, the clutch switch on the pedal may be bad. There is a starter relay in the fuse box under the hood that powers the starter, does it click if you turn the key to start? if it does then the relay is at least trying to work, but doenst mean the contacts inside are good, If it does not click, then the neutral switch may be bad.Check the BLACK/YELLOW wire at the trans switch, if it has power on it, the switch may be bad, ground that (Black/Yellow)wire and see if it cranks. I dont know if there are any other relays in the fuse box that you can swap for the starter relay for test purposes.
49 views
Usually answered in minutes!
×