Question about 2000 GMC Jimmy

1 Answer

My 2000 gmc jimmy is stuck in 4low how do i get it out pushing other buttons does'ent work

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • GMC Master
  • 5,687 Answers

Try putting the vehicle in neutral at a full stop. Then push the buttons-it should shift to the selected gear. Then go back into reverse or drive.

Posted on Jul 04, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2000 gmc jimmy key stuck in ignition-- automatic- no key release button


If you can't get the key out you may need to change out the ignition switch it's not that ******* a gmc

If you need further help, reach me via phone at https://www.6ya.com/expert/scott_87482045335a4757

Sep 06, 2014 | 2000 GMC Jimmy

1 Answer

Stuck 4wd low


I'm not for sure but my suv has low and to get out of it u have to put the trans. in N wait a few then move the switch to 2 wheel and it switches. hope this helps

Apr 05, 2014 | 1995 GMC Jimmy

1 Answer

My 2000 GMC Jimmy is locked up, I can't turn the ignition, or the wheel. Any advice.


I had a similar problem with mine as well... i skip the drama.. as i am working on another problem with the same vehicle.. :( Take off the plastic shrouds behind the steering wheel ( screwes from bottom up. and push the little brass button on the right side approx. 1.5 inches behind the ignition switch.. may just be stuck... push it and may even try some lube to help... i have left off the bottom half of the shroud just in case.. let me know if it helps!!

Apr 12, 2011 | 2000 GMC Jimmy

1 Answer

Four wheel drive stuck in neutral. Won't go into 2high or back to 4 wheel drive. Transfer case was replaced. Its a 2000 Jimmy.


If you have the push buttons on the dash board you must follow the instructions in your owners manual to return the transfer case to 2wd from neutral. I don't remember for sure but I think you must have the transmission in neutral, foot on brake, press and hold both 2wd and 4wdlow buttons at same time. My father who lives 45 miles from me has the Jimmy, I don't. Hope this helps, Jim

Jan 04, 2011 | 2000 GMC Jimmy

1 Answer

Liftgate Release Not Working on a 2000 GMC Jimmy


plug on inside panel of lift gate remove plug and use screwdriver to push on release use light in plug hole

Sep 08, 2017 | 2000 GMC Jimmy

1 Answer

I have a 2000 gmc jimmy and the electrical release won't work.


The solenoid that releases the glass latch is probably stuck (corroded, warn out, needs lubricating, etc.). You will need to remove the rear gate inside panel to see what's wrong and manually release the latch, and then likely replace the latching mechanism.

Jan 09, 2018 | 2000 GMC Jimmy

1 Answer

My truck is stuck in 4LO and the button in the truck dont work.


If its a push button 4x4 take it to the shop its a VERY COMMON Problem dealing with the electric.Once you pay the $400 to get it fixed get rid of the truck and settle for a Jimmy/Blazer/Bravada with a floor shift 4x4..GM had problems with the push button 4x4.DONT DRIVE YOUR TRUCK IN THE MEANTIME.YOU WILL BLOW YOUR TRANSFER CASE RIGHT OUT OF IT!

May 20, 2009 | 1998 GMC Jimmy

2 Answers

97 GMC JIMMY (4X4 PUSH BUTTON PROBLEM)


have a 1998 gmc jimmy stuck in 4-wheel low. the button clicks, and the motor underneath makes noise like it wants to desingage but does not.

Dec 15, 2008 | 1998 GMC Jimmy

1 Answer

1994 GMC Jimmy stuck in 4-wheel low.


Have you tried this: put it in nuetral and push on the brake! Then as your doing these things push the 2 wd button!

Dec 06, 2008 | 1998 GMC Jimmy

1 Answer

2000 jimmy stuck in auto 4 wheel drive


when can you engaged auto 4wheel drive and how long can you run it

Dec 03, 2008 | 2001 GMC Jimmy

Not finding what you are looking for?
2000 GMC Jimmy Logo

Related Topics:

209 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

80263 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...