Question about 1999 Mercury Villager

1 Answer

Engine Shutdown I can start the car but as soon I shift to drive or reverse engin shutdown.

Posted by on

  • gerry bissi May 11, 2010

    go nhere for villager and quest helphttp://groups.yahoo.com/group/villagerqu... you may need to clean your MAF sensor wires with carb cleaner and a toothbrush gently. It affects your fuel ratio.

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Mercury Master
  • 4,369 Answers

Http://groups.yahoo.com/group/villagerquest/files/

sounds like idle air control is bad or needs cleaning. see site.

Posted on Aug 09, 2009

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 218 Answers

SOURCE: error code p1388 no reverse gear only drives forward for 30 seconds restart engine and will drive again

WHAT YEAR IS IT?

Posted on May 07, 2009

Molson02536
  • 3854 Answers

SOURCE: 97 Dodge Caravan Auto-Shutdown Problem

Been working on my dad's 97 Caravan longer then i can remember for things you mentioned and have been not able to get him to sell it.
I found that the electrical connections are prone to corrosion and have replaced lots of the wire and pin connection in the wire harness, thank god i have time on my hands.
The instrument panel where the wire harness connects, i found that the solder goes bad and i had to re solder the connector on the back side of the circuit board, where the harness goes so you need to remove the instrument panel from the dash,
Here is a link that can help you retrieve DTC codes and do research on your caravan. I'ld tell you everything what i needed to do to keep my dad's caravan running but that would be a novel. http://www.allpar.com/fix/stall.html

Good luck and keep me posted, glad to help you keep yours running too.

Posted on May 26, 2009

  • 7 Answers

SOURCE: 2005 DB9 / crank no start

pull out negative terminal battery located under rear right seat.wait for 5 min n then install again the lead negative terminal.insert the key to ignition cylinder.turn the key on off three times.now start the engine.make sure u use recommended fuel grade.

Posted on Jun 21, 2009

  • 3 Answers

SOURCE: Chrysler crossfire engine always stall

I have an excellent mechanic at my dealership.
I ran into the problem your are descrbing. Thought it was a fluke but when It got worse took it to the dealership my mechanic diagnosed it as an intermittant failure of the Crankshaft Sensor.

Posted on Jul 01, 2009

Murphybanton
  • 2004 Answers

SOURCE: check engine light comes on and car starts to downshift hard

Please take the car for a scan to reveal any problem/ error codes causing this.

Good luck,

Posted on Jul 15, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Wont start2004 dodge grand caravan sxt code p0685 show on dash


P0685 DODGE - Auto Shutdown Relay Control Circuit Failure
Possible causes - Faulty Engine Control Module (ECM) power relay
- ECM power relay harness is open or shorted
- ECM power relay circuit poor electrical connection
- Faulty (ECM
Possible symptoms:
Engine Light ON (or Service Engine Soon Warning Light) P0685 Dodge Description: Short or open in Auto Shutdown (ASD) relay circuit, this relay is under the hood in the relay center.

Oct 14, 2016 | 2004 Dodge Grand Caravan

1 Answer

Engine runs for about 30 seconds and shutdown like an electrical shutdown as opposed to a fuel related shutdown.


Engine fired up, ran normally for 30 seconds, then shut down ...

www.thedieselstop.com > ... > 7.3L IDI Diesels (Not Power Strokes)
Sep 25, 2012 - Engine fired up, ran normally for 30 seconds, then shut down. ... it fired up and has been running since... if it just ran out of fuel jump it, and keep ...

Viewing a thread - cummins m11 starts then dies - AgTalk Home

talk.newagtalk.com/forums/thread-view.asp?tid=332921...flat...1

Sep 24, 2012 - 9 posts - ‎9 authors
98 KW with a cummins m11 will start and run for 5 seconds then dies. ... anything else like that, because it would run for 30 seconds and then die, not 5. ... The engineprotection system will not shut down the engine unless the ...

[PDF]John Deere Engine Safety Shutdown with "Black Box" (prior ...

www.tuckerbilt.com/.../John%20Deere%20Engine%20Safety%20Shutdo...
John Deere Engine Safety Shutdown with "Black Box" (prior to Tier II ECU ... Ifengine fails to start in 30 seconds, the Low Oil ... Test #1 (Engine not running).

1800 RPM for 30 sec before shut down [Archive] - Pilots of America ...

www.pilotsofamerica.com > ... > Pilot's Lounge > Technical Corner

Jan 01, 2016 | Cars & Trucks

1 Answer

Whats the codes p0685 an p0688 on a 2004 chrysler pacifica mean


P0685 CHRYSLER - Auto Shutdown Relay Control Circuit Failure

Short or open in Auto Shutdown (ASD) relay circuit
Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
Possible Causes
- ASD relay circuit is open or shorted
- Failed Auto Shutdown relay
- Failed ECM
Tech Notes
Check all the ECM fuses, if the fuses are OK try replacing the ASD relay.

P0688 CHRYSLER - Auto Shutdown Relay Control Circuit Low

The Front Control Module (FCM) has detected the supply voltage below an acceptable value
Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
Possible Causes
- ASD relay circuit is open or shorted
- Failed Auto Shutdown relay
- Failed ECM
Tech Notes
Check all the ECM fuses, if the fuses are OK try replacing the ASD relay.

Dec 29, 2014 | 2004 Chrysler Pacifica

1 Answer

1995 Ford Bronco engine dies when shifted into drive but runs in reverse or 1st gear


Could be fuel filter,air filter,tune up,wires,coils.low idle too low.

Jun 13, 2013 | 1995 Ford Bronco

2 Answers

1997 Carolla- engine dies when shift to reverse or drive, starts again when put in park. Is this a transmission problem or starter/ignition problem?


There is a switch that only only allows you to start the engine in Park or Neutral. It sounds as if yours is faulty or has a bad connection. Finding it will be the problem.

Jun 19, 2017 | 1997 Toyota Corolla

1 Answer

Engine shutdown after 5 minutes


May be a dirty fuel filter. It is basically running out of gas because dirty filter is creating a bottleneck in the fuel system.

Mar 27, 2012 | 1994 Toyota Camry

1 Answer

P0688 2005 pt


P0688 CHRYSLER - Auto Shutdown Relay Control Circuit Low
Symptoms - Engine Light ON (or Service Engine Soon Warning Light)
Possible causes - ASD relay circuit is open or shorted (replace this relay first)
- Failed Auto Shutdown relay
- Failed ECM (engine control computer)

Mar 22, 2012 | Chrysler PT Cruiser Cars & Trucks

1 Answer

I have a 2003 dodge dakota. 4.7l. I get codes p0685 and p0688. No start no spark. Relay is good. But voltage drops when using a voltage meter on one of the grounds in the pdc. Any live wire and that ground...


P0685 DODGE - Auto Shutdown Relay Control Circuit Failure
Symptoms - Engine Light ON (or Service Engine Soon Warning Light)

Possible causes - ASD relay circuit is open or shorted
- Failed Auto Shutdown relay
- Failed ECM
Tech notes Check all the ECM fuses, if the fuses are OK try replacing the ASD relay. P0685 DODGE Description Short or open in Auto Shutdown (ASD) relay circuit

P0688 DODGE - Auto Shutdown Relay Control Circuit Low
Symptoms - Engine Light ON (or Service Engine Soon Warning Light)

Possible causes - ASD relay circuit is open or shorted
- Failed Auto Shutdown relay
- Failed ECM
Tech notes Check all the ECM fuses, if the fuses are OK try replacing the ASD relay. P0688 DODGE Description The Front Control Module (FCM) has detected the supply voltage below an acceptable value

Jun 24, 2011 | 2003 Dodge Dakota Club Cab

1 Answer

Engine overloads when shift to drive/reverse


check and clean your IAC valve, clean intake/throttle body. is your "service engine soon" light on??

Apr 28, 2010 | 2006 Chevrolet Trailblazer

1 Answer

Car will not start in park, but will start in neutrel. Car will die as soon as you put it in reverse.


have your neutral safety switch checked or adjusted. if engine dies as soon as it is shifted to reverse, does it so the same when you shift it to drive? if on reverse only, idle is set too low.

Jul 11, 2009 | 1991 Lincoln Mark VII

Not finding what you are looking for?
1999 Mercury Villager Logo

Related Topics:

59 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

fordexpert

Level 3 Expert

5546 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...