Question about 2001 Jeep Grand Cherokee

1 Answer

I have a jeep cherokee 01 and the check engine

I have a jeep cherokee 01 and the check engine light is on and it says its the injector circuit open cylinder. what dose this mean and can i drive my jeep? will it hurt it to drive it?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 3,600 Answers

Tinyp78 has it right if it has the check engine light on then don't run it as it will damage the catalytic converter, as well if the injector fails and exlodes the parts can go into engine and damage a valve or cylinder.

Posted on Jul 05, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2004 jeep grand Cherokee fuel injectors stay open


If not pulsing, could be a bad pcm. The computer grounds the injectors internally for a split second to pulse them . If trash or debris is not making them stick open, buy a "noid light" for checking injector circuits. Plug it in to #1 or #5 and crank engine over: if circuit is working right, noid light will be blinking. If light is on steady, computer is not interrupting ground to cause pulsing.

Jul 11, 2013 | Jeep Grand Cherokee Cars & Trucks

1 Answer

Electical trouble shooting


Your solution is simple,1998 Jeep Cherokee. The ASD relay gives power to the fuel pump the injectors and distributor also the Oxygen sensor heater circuit. 1st check the fuel pump fuse make sure its not open. If it is open you are dealing with a short to power located at the Oxygen heater circuit,these wire are prone to short together you may have to open the wiring harness and make the inspection if power steering fluid or transmission fluid has degraded the wires you will have to solve for the fluid leaking to protect the harness(wires) from shorting

Dec 31, 2011 | 1998 Jeep Cherokee

1 Answer

No current to injectors 90 jeep cherokee


If the check engine light does NOT come on when cranking, at the times when it won't start, and the relays are clicking and buzzing, then your ECU is in need of repair. The engine will only start after the check engine light comes on and the ecu is what controls that. ECU is likely going bad, causing the delayed start problem typical of early 90's jeeps. Reasonably priced repair or replacement services for your jeep ECU are available on ebay.

Nov 21, 2011 | 1990 Jeep Cherokee Limited

1 Answer

I have a 2004 Jeep GC 6cyl 4WD. My check engine light is on, scanned and got P0203, P0300, P303. Changed the spark plugs, fuel injector #3. Started it up and ran rough, I left it in the garage all night...


codem p 0203 refers to injector 3---circuit malfunction===causes wiring--injector--ECM
chweck for harness connection , bad wire for no 3 injector or corroded pins for no 3 injector in the connection

May 14, 2017 | 2004 Jeep Grand Cherokee

2 Answers

Have a code of p0204. What does it mean


P0204 is cylinder 4 injector circuit malfunction. Try using a fuel injector cleaner additive to your fuel. After you have used that tank of gas, reset engine ecu and see if it doesnt come back

Jun 30, 2009 | 2001 Jeep Grand Cherokee

1 Answer

My 96 v6 4.0 grand cherokee is reading these codes


douple ck all the ground wiresto engine,trans bell housing ,battery or frame/firewall look for any that may have separated from any pack of wires or broken off eyelets then thightnen all points,,.these grounds are very important to comp/injection controls and can cause a multi code problem like yours.

May 05, 2009 | 1996 Jeep Grand Cherokee

1 Answer

2004 Jeep G Cherokee diagnostic code open injector


It could be a faulty pcm or wiring as you stated in you post. the pcm pulses a ground to the injector circuit allowing the solenoid in the injector to activate momentarily are inject fuel into the intake. if you give me the engine size. V8 4.7L or strait 6 cylinder 4.0L and i will post the proper wiring diagram for the fuel injectors to help you out with your battle

Jan 09, 2009 | 2004 Jeep Grand Cherokee

Not finding what you are looking for?
2001 Jeep Grand Cherokee Logo

Related Topics:

216 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...