Question about Lincoln Navigator

1 Answer

How do i remove the front rotors on a 2003 4x4 navigator. iremoved the calipars but the rotors will not come off. I there anything else holding them on the vehicle?

Posted by on

  • llee70 Jul 06, 2009

    There is a small nut (9/16) and retaining pin in the center of the axle. It's hard to tell if the studs are part of the rotor. The replacement rotors do not have the studs attached. I checked with the dealership and I do have the correct replacement rotors.

×

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 224 Answers

Proabably a large nut that goes through the center of the rotor to attach it to the axle. Are the studs for mounting the rims part of the rotor? If so, this is probably your best bet (you'll probably have to specially purchase this socket because it's going to be a 22+mm).

Posted on Jul 04, 2009

  • Joseph Weisenberger
    Joseph Weisenberger Jul 09, 2009

    Okay, try spraying the back of the rotor and the studs with penetrating oil (my preference is Liquid Wrench over WD-40, but either will work). Let this work it's way in for a few minutes and try again. If there is something you can use to pry against, this may help you get the rotors off, but be careful as you don't want to harm your studs.

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2000 lincoln navigator front brakes


If it was okey before you did all that work,
then it isn't bleed correctly

Jun 22, 2012 | 2000 Lincoln Navigator

1 Answer

Cant remove the calipar too change the brake pads on the front


You need to compress the calipar, sounds like a groove in the rotor, a big screw driver works

Aug 09, 2011 | Pontiac Grand Am Cars & Trucks

1 Answer

I can not take the front rotors off on a 1997 dodge intrepid. It looks like 2 nuts hold them on in the middle but im not sure? What do i do? Do the nuts have to come off in the middle to take the rotors...


Yes they do you just need a big enough socket and you need to have someone pushing on the brakes when you are loosening them so do it before you start to remove calipars or pads and there real tight like 140 to 150 ft lbs but with a bracker bar and maybe a short peice of pipe on the end of the bar its not a problem

Nov 22, 2010 | 1997 Dodge Intrepid

2 Answers

On a 1994 Chevy s10 pick up, how do you change the front brakes?


jack up frt end. remove wheels. take note of how the brakes go together. do 1 side at a time so you can use the other side as a referance. remove caliper bolts. use a c-clamp to push in caliper pistons. remove old pads. than remove caliper bracket and rotors.dont be afraid its not a big deal. make sure to check brake fluid level and pump the pedal when the job is completed.

Nov 19, 2010 | 1994 Chevrolet S-10

1 Answer

I am trying to remove the front rotors on my daughters 2004 toy corolla. Iremoved the pads and callipers but now I can't get the nut off of the axle shaft to remove the rotors?


You do not have to remove the axel shaft bolt!!!!! Simply remove the caliper and its mount. Then all you need to do is cut off the retaining washer on one of the wheel studs. Then the disc will slide off. Tap lightly with a rubber mallet to break free any rust that might be cause the rotor to stick to the hub.

May 20, 2010 | 2004 Toyota Corolla

1 Answer

What are the torque specs for the bolts on the brake rotors/calipers?


FRONT CALIPAR TO CARRIER 34NM
FRONT CARRIER TO HUB 107NM
FRONT HUB NUT 294NM
REAR CARIER TO HUB 62NM
REAR CALIPAR TO CARRIER UPPER BOLT 39NM
LOWER BOLT 34NM

Apr 25, 2010 | 2003 Toyota Camry

1 Answer

How do you remove the front rotors on a territory awd,does it require a 32mm deep well socket? The calipars have been removed.


If the calipers have been completely removed and the rotors don't just slip off, then the hub, bearing, and all have to come off.

Oct 31, 2009 | 2006 Ford Ranger

1 Answer

How do you remove the rear rotors from a 2007 Dodge Minivan?


Disc only!!! Remove rear tire. Remove 2 calipar bolts. Hang calipar. Don't leave hang loose. Slide rotor off. If stuck you must adjust the emer. brake, Going around the back side of the backing plate on the bottom. Remove the rubber boot. Using a brake tool or screwdriver adjust the star wheel adjuster to remove the rotor.

Oct 08, 2009 | 2007 Dodge Grand Caravan SXT Minivan

4 Answers

How do you remove the front rotors. I changed my pads but not the rotors. I saw a screw in the rotor with a philip head. I tried using my philip screw driver but it wouldn't turn I was only going to strip...


your rotors are only held on by your brake calipar and wheel when its on..they get rusted on remove wheel break calipar and the rotor should come off use a rubber mallet and beat on rear side and itll pop off.

Sep 23, 2009 | 2004 Land Rover Discovery

1 Answer

Grand am gt 2003


Jack that side up support it with jack stands or blocks, take off tire, take brake calipar off, brake calipar braket, take off rotor, take off axel hub nut, and the 3 bolts that hold the hub assembly on, then bang it off with a good hammer. Installation is just reverse.

Apr 08, 2009 | 2003 Pontiac Grand Am

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

339 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lincoln Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

fordexpert

Level 3 Expert

5546 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Are you a Lincoln Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...