Question about 2003 Dodge Dakota Club Cab

1 Answer

The passenger side door power window and locks not working. The driver side power unit has to be used

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 135 Answers

I would pull the door panel and check the plug in to the switch on the passenger side. It is possible the switch is bad, but usually only one (either the window or locks) will be bad but not both. Sounds like a power problem getting to the switch. As I said I would first determine the door switch is plugged into the harness.

Posted on Jul 04, 2009

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

SOURCE: Power windows, door locks and mirrors inop.

Not a solution for the problem exactly but to the person who pulled his fuse for the dome lamps, all you need to do is turn the interior lights off at the turn signal switch next time. I'm going to have my wiring repaired tomorrow. Thanks for the info.

Posted on Sep 08, 2008

  • 1861 Answers

SOURCE: 2002 toyota celica power door lock problem

Are you hearing any noises from the pass door when you activate the lock switch? If not, the power door lock solenoid has failed, and prob needs to be replaced. Pull the door panel & check to see if it is getting power to the solenoid in lock & unlock. If it has power, the solenoid is def bad.

Posted on Sep 19, 2008

  • 110 Answers

SOURCE: 2004 Jeep Grand Cherokee driver side power windows do not work

i had same problem on my jeep i disconnected the battery then reconnected everything worked fine after that

Posted on Nov 25, 2008

  • 2 Answers

SOURCE: HAVE A 03 GMC SIERRA

I had the same problem in my wife's 2003 Yukon Denali. The power seats and passengers side window wouldn't work. Turned out to be a blown Buss Type fuse in the Underhood Fuse Block. It is the one marked MBEC 1 50amp. Hard to tell if the are blown so look very carefully. Should look like a hoop with two shiny solderlooking bubbles on either side. On my blown fuse, it caught my attention because it looked like the solder was missing and I had to look very closely to see the bottom of the "hoop" was open. They are very hard to remove and must be pulled straight up.
This type of fuse looks like a red square with a clear plastic top showing the fuse link under the plastic. On my vehicle it is on the top row second one from the left.

Posted on Dec 21, 2008

  • 1 Answer

SOURCE: door locks and power window

Just did this procedure I got from coloradofans.com forums:

"any type of power/voltage change seems to trigger this issue

The most common symptom is power locks fail and only the driver window quits, however that is on the extended cab.

Steps to fix and it works every time.

take door panel off driver's door
Disconnect the wiring attached to window and power lock control unit
disconnect battery cables
connect the negative to the positive cable(((NO BATTERY CONNECTED)))
This will act to short residual voltage in the system

5 minutes later
place the key in the ignition and turn to the run position
connect the wiring to the window/lock controller
connect the negative cable to the battery
then the positive
open drivers side door
turn key to the off position((do not remove yet)) you should get a series of dings through speakers telling you the key is still in the ignition
once it begins dinging pull the key out and you should hear the door lock solenoids trigger and the windows should work." - Coloradofans.com forums

Posted on Mar 20, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Passenger power window stopped working with either controls


Power Windows not working - CarGurus

www.cargurus.com > Questions > Honda > Accord

CarGurusOct 9, 2012 - Power Windows not working - I have a 2006 Honda Accord and thepassenger and back power windows quit working all at once. ... My key less entry doesn't work either after I replaced the master Window control unit. 6 out of ...

Passenger Power Window Not Working ' ClubCivic.com - Your Online ...

www.clubcivic.com > ... > Interior / Audio / Electronics
Oct 28, 2009 - My passenger side window is not responding to either the driver side orpassenger side switch. It is in the up position and wont go down.

Jan 19, 2016 | Cars & Trucks

1 Answer

Power lock problem


Hi there I am technical mechanical and electronic engineer mechanic you have a short in the circuit and you have to see wire diagram for it it may be some were else that is cause you the problem with it do a voltage drop test po-po and nev-nev

Oct 25, 2015 | 2006 Saturn ION

5 Answers

Hello I have a 1997 Honda civic ex coupe manual trans, my issue is that the power lock won't work and the passenger side window doesn't work either, the only one working is the driver side power window...


Most probable cause , ,,, when you open & close the door, the wires in the rubber boot (accordian like) harness in between the door hinges, get cut and will cause alot if issues, without burning a fuse !

Oct 25, 2014 | 1997 Honda Civic

1 Answer

Why doesn't my 2000 chevy blazer power windows and door locks and remote mirror doesnt work. Power window on passenger side does work


well, the first thing is to check the fuses and or relay for power windows.should be listed in your owners manual. if ok, then remove switch from drivers side window and check for power. if power to the switch then use a jumper wire from power side to motor side of switch. if window works then its the switch causing the problem. Good-day!

May 04, 2014 | 2000 Chevrolet Blazer

1 Answer

Similar electrical issues with driver's side door controls. Power locks, power window, and power mirror on driver's side are not functioning. I can manually unlock the door, but the buttons on...


CHECK FUSES FOR POWER WINDOW,CHECK FUSE FOR POWER MIRROR AND CHECK FUSE FOR POWER DOOR LOCK.IF FUSE OKAY DOOR CONTROL MODULE FAULTY ITSELF.

Sep 11, 2011 | 2004 Saab 9-3

2 Answers

Doorlocks dont work except from passenger side. mirrors dont work. windows dont work from anywhere


First, check all fuses to make sure that none are blown.

If the door lock switch works on the passenger side, then the drivers side door lock switch is probably faulty. Use a multi-meter to test the Drivers Side Door Lock Switch (Black and Pink/Light Green wires unlock the vehicle, and the Black and Pink/Yellow wires lock the vehicle)
If the switch is tested and found to be operating properly, you may have a faulty Body Security Module or Drivers Side Door Lock Actuator.

If neither of your Power Mirrors are working, you probably have a faulty Exterior Rear View Mirror Switch, Power Mirror Module, or blown Central Junction Box Fuse.

If none of your Power Windows are working, you probably have a faulty Accessory Delay Relay or a blown fuse in your Central Junction Box or a faulty Master Window Adjust Switch (all of the Power Window Switches feed through this Master Window Switch). If the Power Windows didn't stop working at the same time, you may have faulty Window Adjust Switches, or faulty Power Window Motors, this is very unlikely though. It would also be a good idea to inspect the wiring for any obvious damage.

Mar 15, 2011 | 2005 Ford F-150

1 Answer

Power locks don't work with remote or control from


The door lock/unlock input from the driver's key switch goes to the Door Multiplex control unit (main switch), the Door multiplex control unit then sends a signal on the BUS (CAN) circuit to the passenger's multiplex control unit; the passenger's multiplex control unit then controls all the door locks. The passenger's door lock key switch inputs to the passenger's multiplex control unit, if the locks work from the passenger's side key switch but not the driver's side key switch, the most likely cause is the driver's multiplex control unit (main switch) not sending the signal to the passenger's side multiplex control unit. This could also be the drivers side door lock actuator. Hope this helps!

Jan 07, 2010 | 2003 Honda Pilot

3 Answers

1999 Jeep Grand cherokee


Check the wiring between the drivers door and the A pillar(the body of the car). Sometimes the harness breaks from opening and closing the door.

Nov 07, 2008 | 1999 Jeep Grand Cherokee

1 Answer

92 F150 power window and locks


try taking apart and cleanig all contacts first. make sure you are getting power to switch. Sounds more switches are going bad. They usually last about 5 to 7 years before they start going out.

Jun 11, 2008 | 1992 Ford F150 SuperCab

Not finding what you are looking for?
2003 Dodge Dakota Club Cab Logo

158 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8152 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...