Question about 2006 Hyundai Sonata

1 Answer



Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers

I asume you have the car jacked up. Take a block of wood and a hammer hold the wood on the inner part of the wheel (the bit inside the wheel well) and hit the wood with the hammer then spin the wheel 90 degrees and repeat till it comes off.

Posted on Jul 03, 2009

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

How to remove rear wheel

Hi, I hope I can help with this.
You should only have to remove the lug nuts and the wheel and tire will be removed. If you removed the center wheel nut then it sounds like you are trying to remove the brake rotor. To remove the wheel the 5 or 6 lug nuts need to be removed. To remove the rear spare tire there is a plastic cover to remove which then has a key hole (locks for security). You will need to unlock this as well.

Jul 28, 2016 | Cars & Trucks

1 Answer

How do I remove the flat tire

Hi Frank:
- Block the diagonally opposite tire.
- Set the parking brake
- Put the transmission in Park or Low gear.
- Set the jack under the frame or body lift point.
- Jack up until tight against lift point
- Remove trim cover if present
- Use wheel nut wrench to loosen nuts. Do not remove nuts.
- Jack up until wheel off ground.
- Remove wheel nuts.
- Wheel should now be able to be removed. Sometimes they will need a kick to loosen them. If still stuck, reply as a COMMENT to this e-mail and I'll give you some other hints.
If you want to remove the tire from the rim, click on this youtube link.

Jan 21, 2016 | Cars & Trucks

1 Answer

How do you get the tire off a 2005 Dakota once the lug nuts have all been taken off.

Hi Richard:
These can be a PITA!
The diameter of the centre of the wheel can be a nasty tight fit.
Here's a couple of techniques:
- Old brute force trick......... use spare tire as "pendulum" hammer and smack the stuck tire... front.back.front.back
- If front tire, turn all the way to side being removed.... but block of wood between rim and frame.... turn back against rim.
- Put lug nuts back on leave slack. Lower vehicle back to ground and drive slowly forward and back. If front tire, turn back and forth.
Sometimes this will loosen them
- If rear tire, slide 4X4 across from under vehicle. block so it is against rim, then smack 4X4 with LARGE sledge hammer.
- Some people apply heat to the centre of the wheel where it is jammed. I don't like doing that.
BRUTE FORCE is much more satisfying.

Nov 08, 2015 | Cars & Trucks

1 Answer

My rear wheel/tire are stuck on my car,how do i remove

I presume you mean you have removed the nuts and can't get the rim from the hub centre? Sit the vehicle on a jack stand and clout the back of the rim with a stout piece of timber. Leave a couple of nuts on loose to prevent the wheel falling.
Or, loosen the nuts approx half way and drive backwards and forwards at less than walking pace having someone watch the wheel and this flexing of the unsecured wheel will usually free it. Then remove as normal. When refitting clean all the corrosion from the wheel and hub and coat the retaining surface lightly with grease. Don't grease the studs or nuts.

Nov 06, 2015 | 2006 Chrysler Pacifica

1 Answer

How to replace the upper control arm

  1. Loosen the wheel nuts slightly. Raise the front of the vehicle, and make sure it is securely supported.
  2. Remove the front wheel and tire from front hub. CAUTION: Be careful not to damage the hub bolts when removing the front wheel and tire.
  3. Remove the upper arm ball joint self-locking nut(A) and the split pin(B).
  4. Using the special tools, disconnect the upper arm ball joint from the knuckle. Remove the front strut assembly
  5. Remove the two upper arm mounting bolts(A) from the body.

Apr 25, 2012 | 2006 Hyundai Sonata

1 Answer

How to change tire on 2006 Toyota Solara? All 5 lug nuts are removed. Is there a center nut? I believe the rims are a special alloy type.

How many miles...and how cold is it? Many times in bad weather and with mileage, the wheel hub sticks to the rotor...Be sure your jack stands are supported...but you may need to kick, or hit the inside of the tire you are trying to remove...enough of a jolt should loosen the stuck condition...Be sure to lubricate and clean off the inside of the wheel at the contact circle...Hope this helps.

Feb 08, 2011 | 2006 Toyota Solara

1 Answer

Having trouble removing the front wheel. removed lug nuts, but don't know if or how to remove spindle nut

once the lug nuts are off the wheel should come off, if not bang on the tire with a heavy hammer it is stuck on the hub (RUST).

Aug 28, 2010 | 2006 Toyota Corolla

1 Answer

How to change front brake pads on 2006 town and country

Loosen tire lug nuts. Jack up the car and remove lug nuts and tire. Remove two bolts holding the caliper in place. Remove the the two bolts holding pads in place. Hang caliper with a wire from wheel so brake line is not stressed. Mount new calipers in correctly and tigthen pad bolts. Put caliper on and tighten caliper bolts. Replace tire and lugs nuts. Jack car down and tigheten lug nuts.

Aug 17, 2010 | 2006 Chrysler Town & Country

2 Answers

I have a 2006 Eddie Bauer Ford Explorer. The front passenger side tire blew out. I took off all the lug nuts that I could see but I can't get the tire off. Is there a hidden lug nut somewhere? Do I...

If you first jack up the right side with wheel chocks in place and set in park, and take off all of the lugnuts, sometimes the wheel gets stuck to the hub, in the middle, requiring a heavy hammer or heavy piece of metal shaft to hit the wheel at the 6 o'clock position from behind the wheel to dislodge it.

This is a common problem.

Jul 10, 2010 | 2006 Ford Explorer

Not finding what you are looking for?
2006 Hyundai Sonata Logo

Related Topics:

510 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts


Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8215 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides