Question about 2002 Pontiac Grand Am

1 Answer

2002 GA Next step

2002 Grand AM OK My car was not taken in for the recall but I replaced the t/s -Hazzard relay. But it is still making the clicking noise just as before SO NOW do I chance the Turn signal / light control lever?

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

No the clicking is just the relay thats inside the hazard warning switch in the dash its just something you are going to have to get use to

Posted on Sep 05, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Hazzard and lock don't work when I press the button on BMW 2002 325ci

hi have you checked the fuses and relays if they are ok try poping the switch out and make sure that the wires are still conected to the back of the switch

Sep 29, 2012 | Cars & Trucks

1 Answer

Hazzard switch keeps clicking after i use my signal lights

Dear Steve_Borela,

Try pressing the switch again, these are usually DPDT (double pole double throw) switches. Meaning they have a push to make, push to unmake connection. In short your hazard lights are still on. If you have turned them off, then either your switch or a connection issue.

Hope this is the fixya for you.

Yours sincerely


Feb 07, 2012 | 2002 Pontiac Grand Am

1 Answer

Hazzard switch changed still hear clicking

Maybe the flasher unit under dash is bad, shorting out. Do the hazards work at all?

Jan 31, 2012 | 2002 Pontiac Grand Am

2 Answers

Turn signal is constantly clicking without turn signals on. Sometimes fast sometimes slow, just on it's own it starts clicking

It's more than likely to be the multifunction switch , the contacts get dirty and cause the flasher to continue to click . The flasher and hazard switch are one unit behind the dash , that's why you hear the sound from there.

The next step would be cleaning your multifunction switch. Clicking it into place wears away at it, leaving metal shavings in the grease surrounding parts. When enough metal accumulates, it likes to short and constantly complete the circuit.

Good luck and keep me posted, this was a recall and the fix was to clean the grease used, and or replace the unit.

Feb 08, 2010 | 2004 Pontiac Grand Am

3 Answers

Emergencey switch clicks even when turned off emergency switch clicks evan when turn signals are of

there may ber a recall on this problem, it is caused by the turn sigfnal/hazard flasher combination switch relay in the dash, check with the dealer 1st on the recall to see if it applies if not then u will need to replace the flasher unit in the dash, the switch is part of the hazard button and is located behind the ceter panel of the dash here is the whole recall.

2002 CHEVROLET MALIBU -- In December 2004, GM issued a special policy for MY 1999-2000 Alero, Grand Am and Malibu vehicles not covered under recall 03V327. The policy covered turn signal/hazard flasher failure for a period of 10 years or 150,000 miles (whichever occurred first) to provide a no cost replacement of the hazard switch. GM sent letters to owners starting December 30, 2004. In January 2006, GM will update the special policy to include MY 2002 Alero, Grand Am and Malibu vehicles not covered under recall 03V-327. The policy covers turn signal/hazard flasher failure for a period of 10 years or 150,000 miles (whichever occurs first) to provide a no cost replacement of the hazard switch. GM will send letters to owners starting late April 2006. The actions taken by the manufacturer is sufficient to resolve the issues raised by this investigation. The closing of this investigation does not constitute a finding by NHTSA that no safety-related defect exists. The Agency reserves the right to take future action if warranted by the circumstances. Investigation was initiated on September 27 2005. Closed on January 13 2006. For detailed information & supporting documents, see the official NHTSA page concerning investigation #PE05055 »

Jan 25, 2010 | 2002 Chevrolet Malibu

1 Answer

My turn signal works only half of the time. It is a 2004 Pontiac Grand AM.

check lights 04 ga ....or replace the relay.....did it sometimes keep clicking when finished.....relay!

Dec 01, 2009 | 2004 Pontiac Grand Am

4 Answers

Turn signal or emergency flashers wont work. parts store says they cant find a flasher for them. I checked the turn signal fuse and its good. Any ideas?

The flasher is located above the fuse panel. The relays are built into the switch itself. They have a recall on the 4 way flasher switch because it is faulty and causes blinkers not to turn on. Very common Malibu and other Gm problem

Nov 20, 2009 | 2002 Chevrolet Malibu

1 Answer

Renault Trafic 1,9 dci 2002

check other fuses and relays and re set fuel cut off switch

Jul 10, 2008 | 2002 Renault Sportwagon

Not finding what you are looking for?
Cars & Trucks Logo

97 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts


Level 3 Expert

80531 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides