I have Dodge Cargo Ram 3500 with 5.9 from 1998 my problem is dis Car`s engine drive only 20miles/h. The PC-Check haf not a problem on screen. What can i do?

Bernard's Blog: Dodge Transmission Output Speed Sensor

bernardsblog.blogspot.com/.../dodge-transmission-output-speed-sensor.h...

Sep 8, 2009 - My 99 Dodge 2500 Ram won't accelerate..transmission is NOT slipping,.... It has been running fine and the check engine light even cleared itself yesterday.... So it wouldn't go into first gear and then 3 minutes later my check engine ... I have a1997 Dodge Ram 1500 with a 5.9L instead of the stock 5.2L. It ...

Dodge Ram Idle and Stalling Problems - Car Forums at Edmunds.com

forums.edmunds.com > Dodge > Dodge Ram Pickup 1500

Aug 17, 2011 - 30 posts - ‎25 authors
Learn more about Dodge Ram Pickup 1500 at the Edmunds.com ... The crank sensorwas put on however it started stalling again. ... The truck starts fine, but will only runat 2000's RPM and only then if .... Then as I start driving about 1/3 of a mile go dead again, I knockout of gear, crank back up immediately.

WILL NOT GO OVER 30MPH WITH PEDLE TO METAL ...

repairpal.com > Questions > Dodge > Charger > 2006 Dodge Charger

I WAS DRIVING FINE AND THE CAR ACTED LIKE IT GOT STUCK IN ... Then the transmission didn't want to change into 2nd gear. .... Whenever i start up my car theabs and esp light turn on and when i try driving it doesnt go over 30 mph even .... in neutral but not it just wont go up hills and i think it has something to do with

Yes come and go off system check

po700 is just telling you to check the transmission control module for transmission codes. May need a dealer or high tech reader for this.

Car maintenance lights do not go on after a certain mileage but rather for problems which the car sensors can detect such as bad oil that needs to be changed.-------------------------------------------------------------------------------
galletto 2

You need to run an electronic engine control fault test on this. Go here to learn how and read code lists.

POSSIBLE BLOWER MOTOR BAD ,,,PASSENGER SIDE OF ENGINE BAY COVER IN A BOX OR CHECK THE FUESES OR RELAYS

Hi again,

Dodge RAM 3spd auto transmissions (RWD) available for the 3.9L engine were:

3-Speed: A500 (42RH)

3-Speed: A727 (36RH), Sportsman Model

If you can't find your model code on the transmission casing, the vehicle build plate (in the engine bay) should have the factory drivetrain code stamped on it.

Failing this, Chrysler/Dodge should have your transmission details on their database.

If you end up replacing the entire transmission, you might as well upgrade to the improved 4-speed. Most Chrysler/Dodge RAM transmissions were a universal fit, but some had stronger internal components to withstand the higher torque of the larger capacity engines.

I've located a link which has more technical detail on the transmission:

http://www.scribd.com/doc/228727/Dodge-Trucks-TechTran-A500-42RH-A518-46RH-A618-47RH-Service-Manual


Cheers,


"If this has helped you in any way, please rate this solution"

The only way to turn off the MIL (Malfunction Indicator Light) or "check engine Light", is to either use a scanner to reset the MIL, or you can dis-connect the battery for three minutes, but if you do dis-connect the battery you will have to re-set the radio and anything else that has a KAM (Keep Alive Memory).

1999 Dodge Truck RAM 1500 1/2 ton 4WD 5.9L SFI 8cyl
The Fuel Filter is located: Under vehicle, center, below cargo area, mounted on top of fuel tank, in fuel pump module

For other RAM models or engine sizes, I suggest visit autozone.com (free register).

Good luck (remember rated this post).

have the module tested. check for voltage at the dis and coil