Question about 1997 Saab 900

1 Answer

I have power to pump,pump not working,how do i get pump out

I pulled carpet up in back but no cover for fuel pump,just where wires come up

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Saab Master
  • 75,822 Answers

U must remove the fuel tank the wires run under the at not inside.

Posted on Jul 03, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

On my 2003jeep Cherokee with4.0 no fuel to the fuel rail. Why?


Liberty's, you can access the fuel pump from behind the back seat. Pull the carpet up. Pull the plug and check for power. No power, bad wire. Check continuity of the wire from front to back. If it checks OK. Look at the fuse panel. You can also put power and ground to the pump to see it is working. Most likely you can access your's this way.

Jul 09, 2016 | Cars & Trucks

2 Answers

On 99 Mazda Millinia. Where is the fuel pump access panel


Start in the trunk. If you have a spare tire, remove it., pull the carpet to the side, (first open the gas cap to release pressure). back in the trunk you will see the pump access cover, You'll need to unbolt it to get to the pump. Good luck.

Nov 09, 2015 | Mazda Cars & Trucks

5 Answers

Www.datadiy.com


Are you serious ? :)
Next to your driver seat there's a little handle to open the fuel door.

Jun 17, 2014 | 2000 Mazda MPV

3 Answers

Where is the panel for the fuel sending unit in back of the vehicle?


Yes, remove back seat, it is under the passenger side, just pull back the carpet. It is a circular cover held on by 6 screws. Be sure to disconnect your negative battery cable before performing any work on the fuel pump/ sending unit assembly.

May 17, 2014 | 2002 Land Rover Freelander

2 Answers

Were is fuel pump located in a honda accord 1991


The fuel pump is built into the gas tank usually if u pull up the trunk carpet or pull up the bottom part of the back seat you will see a 10" disc with bolts around the edge. This is the fuel pump access cover. The fuel pump is under there.

Oct 23, 2012 | 1991 Honda Accord

1 Answer

2004 grand prix check gas cap light on changed gas cap and still the same problem dont know what to do


Open the trunk, pull the carpet back to reveal the access to the fuel pump. The gas tank pressure sensor is located on top or the fuel pump. The connector has 3 wires, 1 black and 2 colored. Pull the plug off the sensor, put jumper across the 2 colored wires, tape it up with electrical tape. Replace the access cover, the carpet, close the trunk and never see that "CHECK GAS CAP" message again.

Sep 26, 2011 | 2004 Pontiac Grand Prix

1 Answer

1998 Blazer LT 4.3 L V6 No power to fuel pump relay on the relay trigger circuit at any time. Power is there for the fuel pump power circuit if the power was there to trigger the relay New fuel pump...


is the fuse good is the oil full the fuel pump wires run under the drivers carpet is the carpet worn ive seen more than once a hole in the carpet and the wires cut from the heal of peoples shoes

Oct 14, 2010 | 1998 Chevrolet Blazer

2 Answers

Can you replace the fuel pump without pulling the fuel tank


Unfortunately not. I have had some people install a aftermarket high pressure pump inline that has worked however i do not recommend this.
The job is actually not to back, remove most of the gas from the tank, remove the straps ( might need to replace them) and remove the tank partially to expose the fuel line connections. Remove the fuel lines and power connector then remove the tank. Remove the locking ring on top the tank, remove the pump and fuel level sender. Install new pump and re install.

Jul 31, 2010 | 1993 GMC Safari

1 Answer

I have a 1995 Mazda MPV,V6,4x4,I think the fuel is not working


Don't drop the gas tank. Pull back the carpet in front of the rear seat and there will be a square cover closer to behind the passenger seat with 4 screws holding it down. Remove that cover and it will expose your fuel sending unit cover. This will be circular in shape with 6 or 8 small philips head screws holding it in place. Unfortunately they will probably be very rusty and hard to get out. You will first need to disconnect the electrical plug and the 2 fuel lines. After removal of the fuel lines and the screws carefully remove unit to expose fuel pump.

Apr 05, 2010 | 1995 Mazda MPV

1 Answer

Solenoid was bad replaced it fuel relay was making a bad vibrating noise replaced that truck will turn over but now cant her fuel pump running will not start up


Check the fuel pump cut off switch located behind the carpet on the passenger side up unde the heater box, pull the carpet back and see if the button on top of the switch is pressed down, if not there behind the panel passenger footwell right side same thing also make sure the switch has power coming in and going out. BUT! you gotta be quick the fuel pump relay controls this power and only suppllies power for 2-3 seconds then it turns off. so plan ahead get your test equipment all set-up and surn the ignition on if you have power great turn off the key and move test stuff to tho other wire on the fuel shut off switch get ready and turn on the key power good no power bad fuel pump switch but No power to the switch likely a bad ffuel pump relay.

Aug 03, 2008 | Ford Ranger Cars & Trucks

Not finding what you are looking for?
1997 Saab 900 Logo

Related Topics:

34 people viewed this question

Ask a Question

Usually answered in minutes!

Top Saab Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

75822 Answers

rgbypoet

Level 2 Expert

166 Answers

Are you a Saab Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...