Where is the crankshaft position sensor and wiring located on a 2002 dodge caravan

SOURCE: dodge caravan 1997 3.3l Xavierfrancofuenmayor

Had similar problems occur on various Chrysler products manufactured since 1986. What I did was remove the computer from the car and then take a Dremel tool with wire brush attachment and lightly buff all the pins of the computer--tops, sides and backs. After this I then take a jewelers round file and insert the tip into each connector pin hole and very lightly file it to remove any corrision. When I reassembling the connector plug to the computer I placed a good size dab of silicon grease on the plug in the center (acts as a seal when seated). This has eliminated the problem on four different vehicles.

SOURCE: 96 dakota p1391 error

intermittent loss of ckp or cmp.problem is in the distributor.make sure rotor not loose or distributor hold down bolt loose.camsensor on the distributor.also check to see if crank sensor is loose and out of adjustment.

SOURCE: 1996 dodge stratus runs fine till u drive it for a

Have a compression test done while the engine is warm,It sounds like you have a valve sticking open sometimes or maybe even a burnt valve.

SOURCE: cmp or ckp intermittent loss of

Hello. Can any body tell me what is Cmp and Ckp?

SOURCE: I went to auto zone

one is the crank sensor,m the other is the cam sensor-which was it? you should get the actual code so there is no doubt, if you are having a hard time getting it started, it is probably a crank sensor, if it only manifests itself when running it could be either crank or cam sensor.