Question about 2003 Chevrolet TrailBlazer

1 Answer

I have to change the front complacated is it?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Chevrolet Master
  • 3,854 Answers

Not that hard as long as you can get the trailblazer high enough to drop the front differential axle and pumpkin. You have to unbolt the two CV Joint on the inner side and then disconnect the front prop shaft (Drive shaft), the hub locking assembly. Then it's just unbolting the pumpkin and axle shaft from the front frame mounts and dropping it one side first. If you can get under the trailblazer you can see what i am taking about. Good luck and hope this helps. Takes about 45 min to drop the old one from a lift and the right tools. 

Posted on Jul 03, 2009

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How do i change the rear differential oil on my 2011 Ford Ranger

remove the rear cover all the bolts except the top 1 just loosen that 1. Put a bucket under the rear diff and open the diff cover and drain out the fluid. clean and reseal the diff. remove the plug on the front of the diff and fill with the correct diff fluid until it is filled up to the hole and replace the plug, clean up and check for leaks. No leake = job is complete.

Apr 09, 2017 | Ford Cars & Trucks

2 Answers

Can you get free wheeling hubs for a 2003 rav 4 all wheel drive

Not without changing most of the front components out.

Jan 12, 2017 | Cars & Trucks

1 Answer

Front and rear diff on olds bravada I was wondering if I should drain and add gm fluid with gm additive

if the diff oils is in need of a change then it would be wise to change the oils
if the additive is an approved GM additive then it will not hurt to add it
just make sure that the diff's are not limited slip diffs as they require a special oil and then the additive may not be suitable for the oils

Nov 10, 2015 | Cars & Trucks

1 Answer

I have a 1994 Chevy 1500 z71 I have replaced the front diff with the same gear ratio and know my four wheel drive is binding up and idk what is causing it to do that I need help

4wd vehicles in the main do not have 3rd diff in the transfer case (unlike all wheel drive vehicles) to allow uneven torque between front and read diffs to dissipate
that means that if you are driving on hard surface ( sealed roads ) there becomes what is referred to as a torque wind up in the drive train .This places all gears ,chains under extreme pressure and prevents gear changing ( shifting out of gear)
To overcome this problem, only select 4wd when driving in snow ,rain, mud, gravel or any surface that allows the wheels to slip and so even out the torque wind up.
If you had to replace the front diff that may have been the reason as front diffs are predominently weaker than rear diffs because of the way the teeth act on each other and the torque wind up will break the weakest part

Jul 22, 2015 | Cars & Trucks

1 Answer

Front diff will not lock in transfer case works

change out your diff locking selonid on top of your front diff

Jul 17, 2009 | 1994 Chevrolet K1500

1 Answer

This is a awd it keeps burning up front diffs went through 3 used complete units gear ratio is correct tire size is correct only happens on long trips it is a 2004 mercury mountaineer

have someone inspect the rear diff. ive seen diffs changed to diffrent ones and not change the tag. your problem might be in the back. hope this helps good luck

Sep 19, 2008 | Mercury Mountaineer Cars & Trucks

1 Answer

2005 Yukon Front Diff Axle seals

You don't have to remove the whole diff to change the seals, but you will have to seperate it where the shaft meets the carrier housing. There is a clip holding the passenger axle shaft in place that you have to remove to change the seal. The drivers side axle stub can be removed with a little force as there is a spring clip holding that side in.

Sep 01, 2008 | 2003 GMC Yukon

Not finding what you are looking for?
2003 Chevrolet TrailBlazer Logo

209 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides