Question about 2001 Pontiac Montana

1 Answer

How do I get my windshield wipers to operate in sync

The passenger side windshield wiper extends past the window frame of the vehicle

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 15 Answers

Check the bold at the bottom, it might get loosened. Else, the rubber shield got worn out.

Posted on Jul 03, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Which fuse controls front windshield wiper pump


Do the wipers work ? Fuse for wipers is same as washer pump .
Principles of Operation
The wiper motors receive inputs from the following:
  • Multi-function switch
  • Powertrain control module (PCM)
  • Ignition switch
  • Smart junction box (SJB)
The following components are integrated in the wiper motors:
  • Windshield wiper motor module
  • High/low speed relay
  • Run/park relay
  • Washer pump relay
  • Park sense (Hall-effect sensor)
Washer System
The windshield washer and the rear window washer are activated by the internal wiper motor modules when it receives a ground from the multi-function switch between the washer inputs. Depending on the correct ground, the internal wiper motor modules activate either the windshield washer or rear window washer relays (internal) by grounding the respective relay coil. When either module is activated, it connects voltage to the washer pump while the deactivated module provides ground to the washer pump. In this manner, voltage polarity is reversible to achieve directional change of the washer pump and washer fluid.
  • The washer pump is inoperative
  • Circuitry
  • Washer pump
  • Multi-function switch
  • Windshield wiper motor
  • Rear window wiper motor
  • Go To Pinpoint Test I .
Does your expedition have programmable/recall memory option for seats an mirrors ?
Driver Seat Module
The power driver seat and power exterior mirrors are controlled by the driver seat module (DSM) only when the vehicle is equipped with the programmable/recall memory option.
On the Expedition Limited, the power fold exterior mirror option is controlled by the DSM. Before running a self-test or retrieving codes, the power fold switch must be inactive for at least 30 seconds.
This is a complex vehicle , electronics , control modules an serial data communication networks. You mite be better off taking it to the dealer or some other repair shop . There could be DTC'S - diagnostic trouble codes stored in the SJB - body control module !
B1667 Mirror Driver Up/Down Motor Stalled Go To Pinpoint Test D . B1668 Mirror Driver Right/Left Motor Stalled Go To Pinpoint Test D . B1669 Mirror Passenger Up/Down Motor Stalled Go To Pinpoint Test D . B1670 Mirror Passenger Right/Left Motor Stalled Go To Pinpoint Test D . B1735 Mirror Driver Vertical Switch Circuit Short to Battery Go To Pinpoint Test D . B1739 Mirror Driver Horizontal Switch Circuit Short to Battery Go To Pinpoint Test D . B1743 Mirror Passenger Vertical Switch Circuit Short to Battery Go To Pinpoint Test D . B1747 Mirror Passenger Horizontal Switch Circuit Short to Battery Go To Pinpoint Test D . B2312 Mirror Horizontal Feedback Potentiometer Circuit Failure Go To Pinpoint Test D . B2314 Mirror Passenger Horizontal Feedback Potentiometer Circuit Short to Battery Go To Pinpoint Test D . B2316 Mirror Passenger Vertical Feedback Potentiometer Circuit Failure Go To Pinpoint Test D . B2318 Mirror Passenger Vertical Feedback Potentiometer Circuit Short to Battery Go To Pinpoint Test D . B2320 Mirror Driver Horizontal Feedback Potentiometer Circuit Failure Go To Pinpoint Test D . B2322 Mirror Driver Horizontal Feedback Potentiometer Circuit Short to Battery Go To Pinpoint Test D . Normal Operation During normal operation, when the front wiper wash is selected, the windshield wiper motor provides power to the washer pump through circuit CRW14 (BU/WH) and ground is provided to the washer pump through circuit CRW12 (GY/OG) and the rear wiper motor. If rear wiper wash is selected, the rear wiper motor provides power to the washer pump through circuit CRW12 (GY/OG) and ground is provided to the washer pump through circuit CRW14 (BU/WH) and the windshield wiper motor.
    Possible Causes
  • Multi-function switch
  • Open in circuit CRW14 (BU/WH), CRW12 (GY/OG), CRW07 (GY/BN), CRW20 (GY/YE), SBB49 (RD) or GD149 (BK/GY)
  • Short to ground in circuit CRW14 (BU/WH), CRW12 (GY/OG), CRW07 (GY/BN) or CRW20 (GY/YE)
  • Washer pump
  • Windshield wiper motor
  • Rear wiper motor
    This is

Feb 02, 2016 | 2010 Ford Expedition

1 Answer

Passenger side windshield wiper working slow


there is 2 wiper motors . 1 for the drivres side and the other for the passenger. sounds like a bad passenger side motor

Dec 21, 2012 | 2005 Chrysler Pacifica

1 Answer

2000 grand marquis driver's side windshield wiper lifts off windshield


Hello Steve,

From your post, "Finally had enough and stuffed a small block of wood between the driver's side bottom of the molded plastic linkage frame enough to lift the whole thing enough to put a moderate amount of pressure behind the wiper blade..", it sounds like this box is warped or somehow out of alignment. Is it possible for you to buy this box from a wrecking yard? Has you car ever been in a collision? If so the frame may have so un-repaired buckling resulting in the misalignment.

Mar 10, 2017 | 2000 Mercury Grand Marquis

1 Answer

My newly installed windshield wipers on a 2004 Corolla pass over the drivers side window frame. The replacements are significantly longer than the originals. Is there any way to adjust the stroke or d


get proper size normally passenger side and drivers side different lengths ,woul replace them with proper size or you might damager wiper motor

Sep 27, 2012 | 2004 Toyota Corolla

1 Answer

How to replace the wiper motor on a 1994 volkswagon golf


The wiper motor on a Volkswagen is an electric motor connected through a drive linkage to the wiper arms. Windshield wipers are an integral feature for operating a motor vehicle safely. If your wipers are not functioning, or seem to lack the speed or power they used to have, the wiper motor should be removed and replaced immediately
.


Location
  • The wiper motor on a Volkswagen is located directly underneath the plastic cowl cover. The cowl cover is located directly below the windshield.

Removal
  • Begin by removing the wiper arms by prying off the covers at the base of the arms and removing the nuts that secure the arms to the drive shafts. Label the passenger and driver arms so they can be installed in the same positions. They are not interchangeable. Remove the rubber hood to cowl weather seal. Unscrew the plastic fasteners from the driver's side of the cowl cover, then remove this half of the cover. Remove the fasteners from the passenger's side cowl cover and remove this half of the cover. Disconnect the windshield wiper motor wiring harness by separating the plastic wiring connector. Remove the three bolts that secure the wiper motor to the vehicle's body. Pull the motor slightly away from the body, then remove the nut that connects the motor shaft to wiper linkage. Remove the motor.

Installation
  • Place the new wiper motor into position in the cowl and reconnect it to the wiper arm linkage. Then reinstall the three retaining bolts. Reconnect the plastic wiring connector to the wiper motor wiring harness. Place the cowl covers into position below the windshield and reinstall the plastic fasteners that retain them. Reinstall the rubber hood to the cowl weather seal. Reinstall the wiper arms in the same position you removed them from, along with the wiper arm retaining nuts and lower wiper arm covers. Turn the windshield wipers on and test for proper operation. If the wiper blades slap against the bodywork surrounding the windshield, loosen the nuts that connect the wiper arms to the shafts and adjust.

More Read: OBD2 car diagnostic tool

Aug 06, 2012 | 1994 Volkswagen Golf

1 Answer

Driver's side windshield wiper goes past window frame. How can this be repaired?


It could be a relatively easy fix or it could take some effort. First, try repositioning the wiper. By flipping up the end cap of the wiper arm and backing off the set screw that holds it on the wiper motor post. Remember, what position it was in by placing a piece of tape on the windshield. Pull the wiper arm off by pulling it off in line ith the angle of the wiper motor post. Take a close look at the splines of both the wiper blade arm and wiper motor. If either is damaged you will have to replace that component. Estimate the amount of adjustment you need and reinstall the wiper blade arm that amount in relationship to the piece of tape. Tighten set screw and try it.
If it still does it but less then repeat the process until you get it adjusted correctly. If there was no change thing it could be the wiper motor and that takes some effort to replace.

Nov 30, 2011 | 2001 Jeep Cherokee

1 Answer

M LEFT WINDSHIELD WIPER BLADE ON THE DRIVERS SIDE GOES WAY OUT PAST THE WINDOW FRAME. WHEN I SHUT IT OFF IT STOPS IN THE MIDDLE OF THE WINDOW. THE OTHER ONE WORKS FINE


All you need to do is to remove the wiper blades of the driver side and then switch on and off the wipe so that the other wiper is seen to work in correct position. Now switch off and in the parked condition, fit back the driver side wiper to the stem.
The wiper must now work

Dec 11, 2010 | 2003 Chevrolet Impala

1 Answer

1999 oldsmobile silhouette passanger side wiper flew off the van


I had the same problem with my 99 Silhouette...after they put in a new windshield wiper kept going over the side of the window and tearing the blades up....ended up that the wiper arm was out of adjustment ....they came back and readjusted and it was perfect

Feb 16, 2010 | 1999 Oldsmobile Silhouette

1 Answer

2004 grand prix driver side wind shield wiper going past windshield and now is not in sync with other wiper arm,and still moves past windshield and jams up.


The arm is stripped onto the stud its pressed into which is call a wiper transmission. That part mounts to eack ww blade then to the wiper motor. You need a new transmission and maybe a new wiper are as well

Jan 20, 2010 | 2004 Pontiac Grand Prix

1 Answer

Driver side wiper blade doesn't sync with passenger side blade


the wiper arm assembly is stripped for the knurled knob that is sits on.  replace the wiper arm with a new one.

Mar 30, 2009 | 1995 Geo Prizm

Not finding what you are looking for?
2001 Pontiac Montana Logo

Related Topics:

197 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8211 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...