Question about Ford Windstar

1 Answer

'98 windstar, where is the fuel 'cutoff' switch or 'fuel relay switch' located?

Posted by on

  • anthonylreav Jul 03, 2009

    the fuel reset/cutoff switch is located on the drivers side behind the kick panel below the hood release.

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 58 Answers

Should be located in one of the comp in the back, pos on the pass side

Posted on Jul 05, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Tryingn to find fuel pump shut off for a 2005 hyundia accent


pull the relay-- their is no fuel cutoff--fuel reset -or inertia switch on vehicle

Aug 02, 2016 | 2005 Hyundai Accent

1 Answer

1994 GMC Topkick not getting power from the fuel pump. Where is the fuel pump relay located?


Before going there, check your INERTIA SWITCH (INTERTIAL CUTOFF SWITCH). A small accident or a sharp bump can cause the cutoff switch to trip. The switch is located adjacent to the passenger side rear shock tower, and there is a pushbutton to reset (on most Topkick tucks). Carbureted Topkick trucks do not have cutoff switches, and some custom trucks have the inertia switch relocated.

May 13, 2015 | GMC Cars & Trucks

2 Answers

Location of fuel cutoff/reset switch clk 230 K


MB doesn't use a reset switch (AKA Inertia switch) for the fuel pump

May 15, 2014 | 1999 Mercedes-Benz CLK

1 Answer

Location of the fuel pump relay for p38 1998 range rover


Relays are located in the "under hood relay/fuse panel" on the passenger side between the radiator overflow and the battery. Remove the lid and on the underside of the lid you will find the diagram. The fuel pump relay will be indicated by a graphic of a fuel filling station pump. The relay itself is yellow. Also check the pump fuse, located in the same relay box and if needed check your inertia cutoff switch located in the passenger footewell. There is a panel to the right just under the glove box. It has a popout access door but its much easier to remover this small panel and providing clear access to the switch. Push down on the rubber cover on top of the switch. If it is engaged you are ok here. If when you push down you hear a click then the inertia cutoff was switched somehow and this cuts fuel supply. These switches have plastic internal parts and dont take much to fail. Hope this helps. Happy to provide further suggestions if you wish to repost more info. Good luck!

Apr 21, 2013 | 1999 Land Rover Range Rover

1 Answer

Where is located the fuel pump relay on ford windstar 2002


.Here's a picture of it.1999-2003 Reset Button location
The switch is located inside the jack storage compartment found at the right rear corner of the vehicle. Remove the cover and it is behind the thin "foam" covering inside the compartment towards the rear of the vehicle.

It has a red button on the top of the switch, make sure the button is fully depressed. If it is and the vehicle still won't start check fuel pressure at the rail (there is a port on the rail which is under the hood on the engine) with a fuel pressure gauge. If the pressure is ok (about 30 psi) the problem is most likely not fuel system related.
The emergency fuel pump cutoff switch, also known as the inertia switch, cuts power to the fuel pump in the event of an accident - even a slow speed one - any sudden "jolt" can trigger the switch.

Jan 14, 2013 | Cars & Trucks

1 Answer

2001 Mazda 626 Fuel Cutoff Switch Location?


The only fuel cutoff is made by the ECU, relay and fuel pump. There is no additional switch.

Nov 04, 2012 | 2001 Mazda Protege

1 Answer

Santa Fe fuel cutoff switch


The fuel cutoff switch is located on the drivers side strut tower next to the brake master cylinder. press down on the top rubber part and you should hear a click.

Dec 11, 2011 | 2001 Hyundai Santa Fe

1 Answer

98 Windstar fuel pump relay.


Relay is located under the hood in the power box. Under the power box lid shows where the relay is

Aug 31, 2009 | 1998 Ford Windstar

1 Answer

I have a '98 Windstar, replaced fuel filter and pump.


Most fuel pump relay units are located under the dashboard near the steering column. In some cases, the unit is located in the area where the steering column is mounted, or near the engine's firewall. Lift the carpet in the front section of the passenger or driver's side footwell to locate the wooden floor board; the end of the fuel pump relay is typically located near the center of the board

Jul 03, 2009 | 1998 Ford Windstar

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

323 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5501 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...