Question about 2003 Subaru Forester

1 Answer

Nissan primera 2000,just this week having probs wit low revs wen idle or wen slowing down,cut out a couple of times &started after 5-6 mins also bad rattle or clunking noise wen breaking seems to b more at rear

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Expert
  • 4,070 Answers

You may need to replace the sensor or relay for the transmission. about the brakes, try checking the disc pads, it may be too thin, have it replaced

Posted on Jul 03, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Ford Focus c max 1.8 petrol idle problems


This can be caused by a defective Maf sensor and coolant sensor, they will not trigger a code because as long as there is a signal the computer doesn't know the actual engine running condition enough to say the signal from the 2 sensors is wrong, this goes double for MAF sensors, another area is the idle speed control motor.. I want you to read about the problem at the link below.

Ford MAX 2003 2010 03 1 8 Unstable Idle when slowing Technical matters...

May 20, 2016 | 2006 Ford Focus C-MAX

1 Answer

My 96 ford taurus revs high when starting then works it way from 1500 or more down to 800 but fluctuates from 800 to a little over 1000. When putting car in rverse or drive from park engine revs up to...


You need to clean the IAC again and also the throttle valve and bore, use only CRC brand Throttle body cleaner. After they are thoroughly cleaned disconnect the battery for 5 min's and then drive the car in varying condition for a few days. If that doesn't cure the issue you have more serious problems and will need a scan tool to look into the readings from the MAF, TPS and ECT sensors. High idle cold start is normal then slowly dropping after a few minutes. I assume you never had a check engine light. Correct?

Mar 24, 2017 | 1996 Ford Taurus

1 Answer

Nissan Primera 2000 (W) engine starts and ticks over, brillian't. But hit the accelerator and she does not want to go over 1500 rev's and cut's out?


first i would check the injectors by geting redx and putting it in the petrol tank and fill it up and drive it about for abit and rev it up if not the cat could have gone gook luck

Apr 24, 2010 | 1993 Nissan NX

2 Answers

When in park honda odyssey revs up and down between 1000 and 2000 RPMs


is the check engine light on also? it sounds like the idle air control valve is bad. this controls the idle of the vehicle. when it is stuck open it causes too much air into the engine and causes it to rev. when it gets to a set rpm, the pcm cuts fuel. then it turns the fuel back on, then the engine revs, then it cuts fuel........code p0505 will prob be set

Nov 26, 2009 | 2000 Honda Odyssey

4 Answers

I have a 2000 nissan maxima and the problem that i


Idle air control valves short out all the time on these models. You can ohm the motor to check it, but the down side to a shorted iac valve is that it shorts out the ecm if not repaired quickly. when the valve shorts, 12 volts is supplied directly to the ecm and burns the circuit board. The other option is the air flow meter, this is also a very common problem but typically a p0171/p0174 would be stored in self diag.

Jun 14, 2009 | 2000 Nissan Maxima

2 Answers

2004 nissan armada low idle then won't start


I had the smae problem with mine last week, it turned out to be the IPDM Independent power distribution moduel, looks like a big fuse box. I would take it to a side mechanic and have them fix it instead of going to the dealer it took like 45 mins to take the old one out and put the new one in. If you go to the dealer they are sure to charge something crazy. Hope that works for you.

Feb 21, 2009 | 2005 Nissan Armada

4 Answers

Car dies when slowing down or stopping


Disconnect the air hose going to the Idle Air contorl Valve and plug the line with a small screw.
if the problem of the idle goes away and the car runs smooth and doesn't stall at stops, it's the air control valve housing sensor, it's basicall the whole unit thats no good. If it still stalls, clean the throttle body housing and all parts in where the air gets sucked in, put a rag underneath to keep the dirt from dripping down, start the car with somebody inside the car reving up the engine to 2000rpm's to 2500rpm's, then spray in to the throttle with burst of throttle cleaner and you will see the gunk keep coming out, you may have to change your spark plugs after this is done also.

Good Luck BigWillie

May 29, 2008 | 2000 Nissan Maxima

Not finding what you are looking for?
2003 Subaru Forester Logo

321 people viewed this question

Ask a Question

Usually answered in minutes!

Top Subaru Experts

yadayada
yadayada

Level 3 Expert

75824 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8215 Answers

Are you a Subaru Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...