Check engine light on Honda accord something to do whit trans sensor
SOURCE: where is the o2 sensor located on a 1991 honda accord ex 2.2 engine
Further clarification on the O2 sensor location: It is in the exhaust pipe, under the center of the car, on top of the pipe, just aft of the oil filter.
SOURCE: 1998 honda accord obd code P0171 and P0170.
Hi,welcome to fix ya.
p0171 is for a lean fuel condition .A variety of things can cause this code the most common one is a bad o2 sensor but a plugged injector,fuel filter or dirty egr system can cause this as well.
Code P0108 means your MAP sensor circuit is open. MAP means Manifold Absolute Pressure. You should be able to buy one at your local parts store - otherwise, the dealer.
SOURCE: 1998 honda accord check engine light on code p0141
SECONDARY HEATED O2 SENSOR HEATER CIRCUIT FAULT SENSOR 2.
SOURCE: 2002 Honda Accord V6 check engine light on- local
po505 idle air control if this is the code all hondas do it eventully, small problem easy fix u have 2 choices either remove the idle air control motor and clean the inside of it u will find it's black and the spring inside is stuck clean it with carb cleaner or gum cutter any parts store will have this it's a dirty job it will work for awhile but to replace it is recommended its not expensive for a new one which u can get at any autoparts store autozone,advanced,napa etc. there is only 2 bolts in most cases maybe 3 i doubt it though if u go online t google and type in th eyear make and model and engine size in ur case it's a 3.0 v6 and look for idle air control locations u'll find it to do this job a shop will charge u anywhere from 100.00 for diag to retrive the code plus the part and the labor so about 250.00-375.00 it will only take u honestly maybe 15 minutes to perform only tools needed are a 10 millimeter wrench there is only 1 connector to disconnect and ur done if u do this u will still have the check engine light because u have not cleared it from the computer to do this just disconnect the negative battery terminal (the black one or has a neg sign - don't disconnect the positive side +)for 5 minutes then reconnect and the computer will have reset no more light. good luck it really is that easy
963 views
Usually answered in minutes!
×