Question about 1992 Acura Vigor

1 Answer

Started died won't restart,192000 miles, timing belt replaced once, engine still turns over

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert whose answer gotĀ voted for 20 times.


    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 192 Answers

Does it start with the throtttle held open a litle bit. if yes clean throttle body with cleaner and try to start. check to see if there is fuel pressure. if yes the try ignition module.

Posted on Sep 28, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Car died and wouldn't restart. Tried jumping still will crank but won;t turn over. Thinking timing belt.

could be timing belt but could also be a problem with the starter. a bad seal on the starter, loose wire on the starter solenoid. if the car is still cranking then the problem is most likely the timing. timing belt should be replaced every 60,000 miles

Oct 27, 2013 | 2001 Saturn L-Series

1 Answer

Runs eratic........won`t go .....engine makeing noise

Have you checked the timing belt yet ??
Depending on which engine you have, it may be an interference engine, which could damage the valves if the belt breaks while the engine is running or starting.

Apr 22, 2013 | 2003 Ford Focus

3 Answers

Died as i was driving , won't start

Fuel filter,air filter,spark plugs,crankshaft sensor,any codes.

Feb 02, 2013 | 2006 Mitsubishi Galant ES

1 Answer

Replacing timing belt on 2003 hyundai santa fe 2.7


Jul 30, 2012 | 2003 Hyundai Santa Fe

1 Answer

1990 acura integra 4 cyl 1.8L It was running fine, then all of a sudden I'm going around a corner disengage the clutch to shift and the car dies, thankfully it didn't stall in the middle of the...

Check your timing to see if it jumped a bit.
If the timing belt broke, your outer belts would still turn off the crankshaft, but the engine sound, cranking, would be faster than normal, maybe a higher pitched whine. Anything going on like that?
I would think the one blistered plug was caused because it was loose and got too hot. But don't rule out a problem in that cylinder just yet. You may want next to do a compression test just to verify good compression. If it's okay, check fuel pressure. Good luck.

Feb 01, 2012 | 1990 Acura Integra Hatchback

1 Answer

Have 1999 Chev Malibu 2.4L. On startup at times runs rough, strong smell of fuel, code P0300, check engine light flashes, all other systems test fine. Restarting after about 30 min, she runs smooth.

When I see that code and those symptoms I typically start by looking at the timing belt. When the timing belt gets stretched it will cause this code to come up. The other cause could be a bad Crank of Cam position sensor but we need to eliminate the timing belt as the problem first. To check if the timing belt is the problem do a compression check on the motor to see if you have 0 compression on any cylinders. Once you have done that let me know the results and we will proceed to the next series of checks.

Nov 18, 2011 | 1999 Chevrolet Malibu

1 Answer


have you replaced the timing belt?? it may be shot and vehicle is out of time. replacement interval is 105 K miles or 84 months which ever comes first.

Sep 01, 2011 | 2002 Nissan Quest

1 Answer

Engine will turn over freely but will not start. engine was running when it sputtered and died and will not restart on a 2000 Crysler Sebring Coupe, 2.5, 2 door. May have ran out of gas. added 5 gal but...

see if the cam is turning when trying to start the engine (look through the oil filler cap) if its not, you may have a broken timing belt (and engine damage) if it wasn't empty on the fuel gauge I doubt it ran out of gas.

Aug 29, 2011 | 2000 Chrysler Sebring

1 Answer

Hi, I have a transit t260 2.0 diesel engine 2002 that now won't start? I hadn't started it for a month before today. Today I started it, it fired up first time drove it for about half a mile, it...

I think it is i will probably have to pull the timing belt, it sounds like it probably skipped due to the serpentine belt cords wrapped around something under the timing belt cover, any other suggestions on alternate causes before I start pulling the brand new timing belt?12

Jul 16, 2011 | Ford Transit Connect Cars & Trucks

2 Answers


sounds like a bent push rod or bad starter

Nov 20, 2008 | 2003 Kia Rio

Not finding what you are looking for?
1992 Acura Vigor Logo

Related Topics:

80 people viewed this question

Ask a Question

Usually answered in minutes!

Top Acura Experts


Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you an Acura Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides