I need to remove back door panel to get to revers light wiring for rear view camera
SOURCE: 2004 Nissan Murano How do you clear maintenance light after oil change?
press maintanence button until you see engine oil, then hold trip/reset button... :)
SOURCE: '06 Nissan Murano factory radio/cd player removal steps
what holds the radio in place besides the 2 side screws in a 2006 nissan murano
SOURCE: 2004 Nissan Murano, back door can't open
I had a similar problem with a sienna and sometimes the cable ( inside the door) between the handle and the latch gets stuck in the sleeve. Kind of like the brake cable on a bike.
take the panel off by removing all the screws you can see on the panel and pull the panel off. There will be plastic pins holding it. Some of them may pop off and some will break off.
Drip oil down the sleeve so the cable slides freely. I used bike chain oil. Do not use WD40. This is **** and will not work for very long. Try the handles a few times before you put the panel back.
SOURCE: 1991 Nissan Maxima: Removal of front driver side door panel
This is out of my haynes manual
1 disconnect negative battery cable
2 on manual window equipped modesl remove the window crank using a hooked tool to remove the retainer clip.
3 on power window equipped models pry out the armrest switch control plate and disconnect the electrical connections
4 detach the armrest pull handle retaining screw then remove the inside door handle trim bezel
5 insert a wide putty knife, a thin screwdriver or a special trim panel removal tool between the trim panel and the head of the retaining clip to disengage the door panel retaining clips.then remove the remaining door panel retaining screws at the lower edge of the door panel.
6 once all of the clips are screws are disengage detach the trim panel disconnect any electrical connectors and remoe the trim panel from the vehicle by gently pulling it up and out.
7 for access to the inner door remove the door panel support bracket then peel back the watershield taking care not to tear it. it install the trim panel first press the watershield back into place. if necessary add more sealant to hold it in place.
8 installation is the reverse of removal
SOURCE: Replace rear wiper on 2005 Murano
You probably already figured this out, but you have to remove the wiper arm completely in order to replace the wiper blade.
The blades are an unusual size (somewhere around 14 1/2") and I believe they are only available from a Nissan dealership. They include printed instructions in the box but just in case, this is from the official Nissan service manual:
175 views
Usually answered in minutes!
×