Question about 2003 Ford Expedition

1 Answer

I have 2003 EB Expedition with 85K miles. The start has not been smooth, however Ford says it's fine. Now it has begun to hesitate, almost stall when driving. Occasionally it makes a noise as if it's about to turn off.

Posted by on

  • 4 more comments 
  • Anonymous Mar 11, 2014

    It's eating nylon gear wheels and the cylinder does not rotate freely when pushing it manually so it's a pain putting it back in the garage as I have to lift the mover such that it runs on its front plastic rollers.
    ALSO cable that engages the blade rotation is too long such that I have to physically pull the cable to get rotation - it I cut the nipple off the end to shorted the cable then there will be nothing on the end of the cable to engage in the bracket that connects to the pully wheel spring

  • Anonymous Mar 11, 2014

    please help urgently

  • Anonymous Mar 11, 2014

    misfire on number 4 cylinder replace plugs and wires and cap

  • Anonymous Mar 11, 2014

    how to get to blower motor resistor on 1995 camry

  • Anonymous Mar 11, 2014

    The glow plugs will not work, I have to use starting fluid to start her. The transmission won't change automacticly, have to manually shift. the overdrive swtich is out and not working Had trouble, turned key no juice to starter. Run a new wire but other things (listed previously) not working

  • Anonymous Mar 11, 2014

    no spark no injector pulse

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 3,917 Answers

Hi,

fuel pump may be going. try this. turn key on, listen for fuel pump to run for 5 seconds. Turn key off, wait 15 seconds or until you hear relay click inside car. Turn key on again for 5 seconds and ff for 15 seconds. repeat once more. This will pressurize fuel system to 40 psi so injectors have full pressure. If it starts quickly now, you are getting bleed down through the check valve in the fuel pump or the fuel pressure regulator on the fuel rail.
About the noise there may be serveral reasons like: have the front wheel caster and, camber checked and, set by an auto shop before your wheel bearings fail
or Sounds like you need to get a wheel alignment, this usually needs to done after any repairs done to the tie rods, center links and/or suspension work. As far as price its usually done for under a $100 usually depends on the vehicle
or brake pads might have gone loose. have it checked!
Thanks for contacting Fixya

Posted on Jul 03, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why doe;s my 97 Ford expedition stall only when turning into a parking place or my drive way?


there is a sensor that will increase engine revs when turning at slow speed , i expect this is the issue, to check get the OBD codes read to confirm

Oct 23, 2014 | Ford Expedition Cars & Trucks

1 Answer

2003 Ford Expedition XLT acts like it is starving for fuel. It starts up just fine but once going down the road it then hesitates and wants to bogg down. It has a really hard time on an incline. What could...


You need to install new spark plugs every 70,000 miles

If that was done, then you have a worn out TPS Sensor,
and possibly a bad COP Igniton Coil as well

You will get 1 or 2 coils a year go bad

If it is just on hills, when you have a high vacuum load,
then check out the EGR Valve

Mar 28, 2011 | 2003 Ford Expedition

1 Answer

My Ford 2000 Expedition eb will not start. I've replaced the battery starter still nothing just clicks.


my ford 2000 expedition eb will no start; batery ok starter ok selenoide ok

Jun 20, 2010 | 2000 Ford Expedition

1 Answer

I have a 2003 ford expedition starting problem


hook up a fuel pressure guage and check it at start up, key on pressure should build and hold , if not check it could be regulator of leaking injector

May 20, 2010 | 2003 Ford Expedition

1 Answer

Ford 2003 Expedition EB. Check Charging System


Its probably the alternator. It will need to be tested on the vehicle with the engine running and the light illuminated. Measure the battery voltage with the engine running. It should be at least 13.5 volts. If it is lower have the alternator tested at a shop with a charging system tester.

Feb 27, 2010 | 2003 Ford Expedition

1 Answer

My 2003 expedition EB vibrates when applying brakes


the front rotors are warped ahd either need to be turned or replaced. use quality parts and motorcraft pads. if you use cheap rotors, they stand the chance of either being warped upon install or warping soon after.

Nov 08, 2009 | 2003 Ford Expedition

1 Answer

2003 ford expedition hesitates and stalls out


check all vacuum lines and may try a higher octain gasoline and if that don't work then maybe a tune up.

Sep 24, 2009 | 2003 Ford Expedition

1 Answer

2000 Ford Expedition EB runs rough and begins to shake and stall


I personally would start with the one that runs cylinder #3 and then take it from there.

Mar 09, 2009 | 2000 Ford Expedition

Not finding what you are looking for?
2003 Ford Expedition Logo

Related Topics:

24 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

fordexpert

Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...