Want to know how to get light to go away, what solutionscare therevtobfix thiscproblem?
SOURCE: 1999 Toyota 4Runner .front brakes
To change these pads is simple. You first should wash down the area with brake clean so you don't inhale the dust. Then they are to pins that go through the top of the pads and the caliper. (This Caliper has pistons on bothsides) You them remove the metal clips that hold those two pins. with a needle nose pliers. after removing the clips you will be able to remove the two pins and remove pads. Using the old pads in place you can then push back the piston to make room for the new pads.
SOURCE: 1991 honda civic brake light stays on need to push brake pedal to
Sounds like you might have a caliper that is stuck and is not fully disengaging. If it is in the rear then you may have a bad rear caliper. Twoo things you can try. One is to crawl under the ca and adjust the tension two nuts on the emergency brake line. If that does not resolve the problem then remove the back tire and try to spin the drum or rotor whichever you may have. If it does not spin then try adjusting the e brake cable more if it still does not respond then you need to do a brake rebuild. Also does it pull while it is dragging? If it is then you will need to rebuild the brakes no matter what.
SOURCE: i have a 1995 nissan
abad sensor on one of the wheels for the abs a proffesional scanner will tell you which one
SOURCE: emergency brake light stays on on my 03 tahoe
I have an '03 Chevy Tahoe and I had a similar problem. I discovered that there is a bare copper striking plate or tab that the medal emergency parking brake pedal touches when the emergency brake is set. It turns on the idiot brake light in the dash. It had broken off and the light stayed on all the time with the say issue of chiming whenever the vehicle is in motion. You or the dealership must replace that striker plate to fix the problem.
413 views
Usually answered in minutes!
×