i need to replace the engine sump (3SGE), is this have a gasket seal that needs replacing also?

Raise engine with special tool 00 0 200 approx. 5 mm.
- Remove suction filter housing. Remove engine splash guard.
- Drain engine oil. On vehicles with automatic transmission:
- Disconnect oil lines from automatic transmission and from oil pan.
- Release guide tube for dipstick.

Note: M52TU and M54 only.
- Detach return hose from cyclone oil separator on oil dipstick guide tube.
- Replace O-ring.
- Remove front end reinforcement.
- Detach steeling spindle from steering gear.
- Remove vane pump for power steering unit (lines remain connected).
- Disconnect plug connection to oil level sensor.
- Loosen top and unfasten bottom of left and right engine mounts.

E46 4WD only
- Remove left and right swivel bearings.
- Remove output shafts. Remove front propeller shaft.
- Remove front axle differential.
- Detach brackets for left and right control arms from engine carrier.
- Release retaining brackets for left and right stabilizer bars.
- Unfasten screw connection on front axle support and lower the front axle support.

Note: There is no need to detach the steering gear from the front axle support.

- Unfasten oil sump screws at transmission and engine ends.
- Lower and remove oil sump.
Sealing faces clean and free of seal debris.
Apply approx.3 mm wide, 2 mm high coat of Drei Bond 1209 sealing agent to the area around seams.

Installation:

Replace gasket
Install oil sump.
Insert all oil sump screws.
Insert screws in transmission end without preload at this stage.
Tighten down screws in engine end.
Tighten down screws in transmission end.

E60 Removing And Installing, Sealing Or Replacing Oil Sump (M54)

Necessary preliminary tasks. -
- Remove intake filter housing
- Remove guide tube for oil dipstick
- Lowering front axle support
- Drain off engine oil
- Disconnect plug connection to oil level sensor.

On vehicles with automatic transmission:
- Detach oil lines from automatic transmission and from oil pan.
- Unfasten oil pan screws at transmission and engine ends.
- Lower and remove oil pan.

Installation:
Sealing faces clean and free of seal debris.
Apply approx.3 mm wide, 2 mm high coat of Drei Bond 1209 sealing agen to the area around seams.

Installation:

Replace seal.
Install oil sump.
Insert all screws on transmission end, without preload at this stage.

Tighten down screws on engine end.
Tighten screws on transmission end.

Or take it to a dealer....

Read full answer

Apr 19, 2011 • BMW 330 Cars & Trucks

0helpful

1answer

I have a 1989 honda accord dx with a oil pan gasket leak and a rear main seal leak, in order to fix the rear main seal leak, does the oil pan and the oil pan gasket need to be removed and does the gasket...

they don't use gaskets on oil sumps its sealant glue and yes u will have to reapply it when you put the sump back on, and what do u mean by main seal? do you mean the head gasket?

Read full answer

Nov 18, 2009 • 1989 Honda Accord 4 Door

2helpful

4answers

Oil leak at the bottom of the oil pan. Still leaking after i tightend the pan bolt. What should i check next, can this cause other problems?

Dear Sir,
Here is the oil leaking Problem Identifying Technique

Engine oil leaks from the valve cover gasket are common.

The intake manifold plenum gasket may leak and cause increased oil consumption/burning and a spark knock during acceleration; the gasket should be replaced.

External oil leaks from valve cover gaskets, intake gaskets (front or rear), and the rear crankshaft (rear main) seal area are common. The rear main seal is an unlikely source. Normally, the bearing cap mating surfaces (as well as the sealing surface between the oil pan and bearing cap) are the source for the leaks.

Engine oil leaks at the distributor can be misdiagnosed as leaks from the intake manifold seal, oil pan gasket, or rear crankshaft (rear main) seal. A revised distributor is available if oil is found inside the distributor.

If the oil filter casing shows signs of distortion from excessive oil pressure, the oil pump should be replaced.

Often misdiagnosed as a leaking oil filter gasket, the oil filter adapter can seep from between the adapter and engine block.

Carbon buildup on the top of the piston is common. As the buildup increases with mileage and over time, symptoms may vary from light ticking, to ticking/hammering, to hammering/knocking noises. Fuel injector cleaner often solves the problem.

I think it helps to analyse u r Problem

Read full answer

Jul 10, 2009 • 2004 Jeep Grand Cherokee

Related Topics:

Toyota mr2 1994

1 Answer

Anonymous

Add Your Answer

Attachments: Added items

Related Questions:

Reset oil meter after oil change

How to replace oil pan seal

Fuel is getting into oil pan

Does part oil filter screw onto,unscrew from oil pump

HOW DO YOU REPLACE OIL PRESSURE SENSOR FOR 2006 IMPALA V6

How do i remove oil pan

Oil pan 2007 trailblazer

Need to replace oil pan on a bmw 2004 330ci

I have a 1989 honda accord dx with a oil pan gasket leak and a rear main seal leak, in order to fix the rear main seal leak, does the oil pan and the oil pan gasket need to be removed and does the gasket...

Oil leak at the bottom of the oil pan. Still leaking after i tightend the pan bolt. What should i check next, can this cause other problems?

Not finding what you are looking for?

1994 MR2

Reset oil meter after oil change

Ask a Question

Check Out the Latest Top Trucks Report!

Top Toyota Experts

ZJ Limited

Thomas Perkins

ROBERT GARCIA

Are you a Toyota Expert? Answer questions, earn points and help others

Manuals & User Guides

Related Topics:

Toyota mr2 1994

1 Answer

Anonymous

Add Your Answer

Attachments: Added items

Related Questions:

Reset oil meter after oil change

How to replace oil pan seal

Fuel is getting into oil pan

Does part oil filter screw onto,unscrew from oil pump

HOW DO YOU REPLACE OIL PRESSURE SENSOR FOR 2006 IMPALA V6

How do i remove oil pan

Oil pan 2007 trailblazer

Need to replace oil pan on a bmw 2004 330ci

I have a 1989 honda accord dx with a oil pan gasket leak and a rear main seal leak, in order to fix the rear main seal leak, does the oil pan and the oil pan gasket need to be removed and does the gasket...

Oil leak at the bottom of the oil pan. Still leaking after i tightend the pan bolt. What should i check next, can this cause other problems?

Not finding what you are looking for?

1994 MR2

Reset oil meter after oil change

Related Topics

Ask a Question

Popular Questions

My Toyota Mark X 2006

Replace a burned-out bulb or headlight on a 2003 Toyota Camry XLE

There is water leaking into compartment behind

Remove headlight 2002 toyota mr2

How to adjust handbrake cable

Check Out the Latest Top Trucks Report!

Top Toyota Experts

ZJ Limited

Thomas Perkins

ROBERT GARCIA

Are you a Toyota Expert? Answer questions, earn points and help others

Manuals & User Guides