Question about 2003 Nissan Altima

1 Answer

Engine warning light on Nissan Almera 03

My Nissan Almera (2003) was a bit jerky when I first start the engine in the last couple of days and didn't think much to it.
Yesterday, I was overtaking and then all the sudden the engine stopped, and there was no power for few mintues, Couldn't even switch the indicators on.
This morning when I started the car, the engine warning light came on and after few mintues of driving the engine stopped and there was no power for a
couple of mintues again.
Does anybody know what's wrong? and how much it'd cost to fix. It's the last thing I need as I'm struggling financially.
Thank you.

Posted by on

  • Susan Harrowing Aug 26, 2013

    I have a 2003 Nissan Al,era Tino se, 1.8 which has had the same trouble for the past six months, No mechanics have been able to tell me what the problem is as yet, we have replaced spark plugs and Mass Airflow Sensor, having been told that these were the most likely faults but unfortunately this has not remidied the intermittent loss of power fault. I would also be very grateful for any help as to how to rectify this as i do quite a few miles every week with my children in the car and it is dangerous at times, depending on when the engine decides to lose power! Thank you.

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 15 Answers

Its very simple. You can see a black hose from the engine which connects the metal pipe. just remove it and you can see three gold color pin from the metal pipe. scratch that pins using a salt paper and fix it. Now check whether you get started or not. Thanks.

Posted on Jul 03, 2009

  • 1 more comment 
  • Michael Kong Nov 14, 2011

    My Almera SVE (53) just started having similar problem. Had a look under the bonnet and all pipes are black in colour. Would be useful if it can be more specific on which metal pipe.
    Thanks

  • Susan Harrowing Aug 26, 2013

    This did not work but thanks for trying. Any other massively useful ideas please? Trial and error to find the cause but i am getting rather bored of it now!! Thanks

  • Madelein Katzke
    Madelein Katzke Aug 14, 2014

    plz help my nissan micra engne check warnning light came on what must a check for

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Loss of power on acceleration & hills no warning lights showing


Have the codes read anyway. Turn the key on, do you see a check engine light? We work on auction cars also. To many times I see that the light is not on.

Sep 10, 2016 | Nissan Cars & Trucks

1 Answer

Nissan almera tino1.8 engine management light on cooling fan always on and not hot and cutting out after a mile


Get car scanned at a partplace. Radiator fluid cud b low. But system has some component or sensor issue. Unplug computer coupl times...connection pins cud lack good contact...its a commoncure

Jan 18, 2016 | Nissan Cars & Trucks

1 Answer

Where is the fuse bord of Nissan almera 1.6 2004 located


There are 3 Fuse panels in a 1.5 Almera : 2 are located in the engine bay beside LH+RH Main Lights,and both are Engine related,
The other is located below LH dashboard, once pulled a Grey Pocket.t(1.6 does no longer exist since 2000, by least in Europe)

Dec 14, 2014 | Nissan Cars & Trucks

1 Answer

Almera


What did you use to clean the MAF?
You may have damaged the sensor.
I would suggest a used MAF assembly be installed and use only approved cleaners next time and be gentle when cleaning electronics.

May 17, 2017 | 2005 Nissan Almera 1.6

1 Answer

Have replaced the battery on a nissan almera tino and now it won't start. It turns over OK but will not fire.


I changed the battery as it was struggling to start over a few days and then died completely after being left over a weekend. After the replacement all electrics worked but the engine wouldn't turn over, it just clicked. There was no immobiliser warning or messages on the screen. I tried a few of the things on this forum but it turned out to be a broken battery earth cable where it attaches to the gearbox under the car. I removed the cable (easier with the battery tray removed) then had a new lug attached to the end. Total cost 1.50. phew!

Jan 16, 2012 | 2005 Nissan Almera Tino

2 Answers

2005 nissan almera,1.5letre.. fault code po725


P0725 NISSAN - Engine Speed Signal

The P0725 Codes is triggered when TCM does not receive the engine speed signal from ECM.

The Engine Control Module (ECM) monitors the engine speed through the Crankshaft Position (CKP) sensor with the engine running, and send signal to the Transmission Control Module (TCM).

Symptoms:
- Engine Light ON (or Service Engine Soon Warning Light)

Possible causes:
- Open or shorted CKP sensor circuit condition
- Poor CKP sensor electrical connection
- Check communication error between the ECM and TCM
- Failed CKP Sensor

Possible solution:
Very common problem with Nissan vehicles, usually replacing the Crankshaft Position sensor takes care of the problem.

Keep us updated.

Feb 12, 2011 | 2005 Nissan Altima

2 Answers

My engine exhaust warning light is on, amber, in my 2000 VW Beetle it was MOT-ed just last month and passed is it just a sensor issue or is it more serious?


have the car put on a diagnostic machine,it will tell you straight away.(souds like cat converter or lamda probe.....)

May 12, 2010 | 2000 Volkswagen Beetle

2 Answers

I have yellow engine warning light on 2003 nissan almera tino.had cam sensor replaced;still comes on.any reported simlar problems


I have not used my nissan micra 2003 for 7 months it has been stored in the garage but the engine has been started on a weekly basis but today the warning engine light has come on, the car has only done 2300 miles, SHOULD I BE WORRIED or is it because the battery has been disconnected in between starting the engine so it didnt drain the battery while it was standing in the garage unused, this has happened the day before i take it for a mot.....

Jan 17, 2010 | Nissan Almera Cars & Trucks

1 Answer

There is a yellow warning light on in my nissan


fuel sensor, bad or dirty fuel injectors, fuel pump. wiring or timeing belt.. i wan to saywiring or timing belt

Jun 02, 2009 | 2001 Nissan Altima

Not finding what you are looking for?
2003 Nissan Altima Logo

2,344 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

713 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...