An expert who has achieved level 2 by getting 100 points
An expert that got 5 achievements.
An expert whose answer got voted for 20 times.
An expert who has written 20 answers of more than 400 characters.
Re: I need a wiring diagram for the fuelpump
I do not have a diagram. Try this. Check for 12V at one of the wires with the ignition key on; you may need to do this a few times because the voltage will only be on for about 8 seconds. Have someone turn ignition on and off. Do not crank but if you do, voltage will be there also. Then that would be the fuel pump hot wire. One will be ground. Also ground the wire one at a time, if the gauge moves, then that is the fuel gauge wire. The other would be ground or there could be a body ground generally speaking. How many wires goes to the tank?
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Look underneath the hood for a black and white sticker. This sticker will show the correct routing guide for your 1995 Toyota Corolla alternator belt. Click on the link below and follow this "step by step" guide to change your belt.
The procedure to replace alternator is as follows:--
1) Determine which alternator your Toyota Corolla needs. Be sure the new alternator is compatible with your Corolla's engine.2) Disconnect the negative battery cable with a socket wrench. Remove the gravel shield if you need to access the alternator from under the car. Remove the electrical connector and unfasten the retaining nut on the alternator terminal with a socket wrench. This allows you to remove the battery terminal wire. 3) Remove the drive belt. Unfasten the two mounting bolts on the alternator with a socket wrench and take the alternator off the vehicle. 4) Install the new alternator assembly. Use a torque wrench to tighten the smaller mounting bolt to 18 foot-lb. and the larger one to 40 foot-lb. 5) Connect the electrical harness and battery terminal wire to the alternator and fasten the retaining nut to the alternator terminal with a socket wrench. Thanks. keep updated for any more
query.you can rate this solution and show your appreciation.
An engine from another Corolla up to 1997 will fit. There are 2 engines though. 4A-fe (1.6L) or a 7A-fe (1.8L) They look similar but run different Engine managment computers. The 4A-fe uses a 3spd auto trans and the 7A-fe uses a 4spd auto trans. Also some of the wiring may be different.
Hope this helps.
i checked 2 resources and they match , have you tries this schematic , see if you have a match to your cars wiring . actually this code matched corolla 88-92 , and also i checked all models of corolla and it matched , and from looking at the connector this is the order they are in lt green pink grey blue/yellow blue voilet brown red black white yellow
looking at the connector , the only thing i don't see is the green illumination wire . if this is not a match , please comment back , what your wires are , and i will match them . thanks