Question about 2002 Chevrolet Cavalier Coupe

1 Answer

Same problem P0758 Shift Solenoid B Electrical

2004 chevy tahoe, check engine light , scaned with obd2, no noticeable problems, as of yet. Any ideas on where to start looking, possible solutions?

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 10 Answers

The shift selenoid is located on top of the transfer case its a pain to get to there should be an electrical connection on it first check to see that its connected.I have had an 95 blazer and an 03 truck and i hate chevy 4 wheel drive systems i would rather have manual lockouts,

Posted on Jul 03, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

1996 plymouth breeze transmission wont go into 2nd Gear

Have you check fluid level ? Is your check engine light on ? You have a bad shift solenoid inside the transmission ,more then likely . Have codes checked ,you mite have P0700 + code
  • P0750 - Shift Solenoid A
  • P0751 - Shift Solenoid A Performance or Stuck Off
  • P0752 - Shift Solenoid A Stuck On
  • P0753 - Shift Solenoid A Electrical
  • P0754 - 1-2 Shift Solenoid Intermittent
  • P0755 - Shift Solenoid B
  • P0756 - Shift Solenoid B Performance or Stuck Off
  • P0757 - Shift Solenoid B Stuck On
  • P0758 - Shift Solenoid B Electrical
  • P0761 - Shift Solenoid C Performance or Stuck Off
  • Nov 08, 2015 | Plymouth Cars & Trucks

    1 Answer

    2-3 shift solenoid circuit

    P0758 Chevrolet P0758 Chevrolet - 2-3 Shift Solenoid Circuit Electrical
    Possible causes
    - Low transmission fluid level
    - Dirty transmission fluid
    - Faulty 2-3 Shift Solenoid Valve
    - 2-3 Shift Solenoid Valve harness or connectors
    - 2-3 Shift Solenoid Valve circuit is open or shorted
    What does this mean? When is the code detected?
    When the Powertrain Control Module (PCM) detects a continuous open, short to ground or short to power in the 2-3 Shift Solenoid (SS) valve circuit, then DTC P0758 sets.
    Possible symptoms
    - Engine Light ON (or Service Engine Soon Warning Light)
    - Transmission will not shift gears
    P0758 Chevrolet Description
    The 2-3 Shift Solenoid (SS) valve controls the fluid flow acting on the 2-3 shift valves. The 2-3 SS valve is a normally-open exhaust valve that is used with the 1-2 SS valve in order to allow four different shifting combinations. The solenoid attaches to the control valve body within the transmission. The Powertrain Control Module (PCM) controls the solenoid by providing the ground path.

    Read more:

    Jul 14, 2014 | 2000 Chevrolet Silverado 1500

    1 Answer

    Multiple DTC's Solenoid, Torque Converter related... I ran an ODB II read & these are the codes it returned: P0740 - Torque Converter Clutch Solenoid Circuit P0753 - Shift Solenoid A...

    For starters I would run a fault code check to find out what item was affected . Next if nothing was amiss I would run the fault code reader to reset the CPU and see what parts of the CPU program was now working.

    Nov 01, 2013 | 2004 Chevrolet Silverado

    1 Answer

    I have 1998 volkswagon jetta with the check engine code P0758

    P0758 Volkswagen - Shift Solenoid 'B' Electrical

    Possible causes
    - Low transmission fluid level
    - Dirty transmission fluid
    - Faulty shift solenoid 'B' valve
    - Shift solenoid 'B' valve harness or connectors
    - Shift solenoid 'B' valve circuit is open or shorted

    Worst possible scenario is that the Transmission Control Module has noticed the solenoid is either taking too much current (a short circuit) or too little current (an open circuit). The problem could be in a few different places: wiring between the TCM and the tranny, wiring internal to the tranny, the TCM has gone bad, or the solenoid itself. You can narrow this down by checking the resistance of the solenoid coils at the TCM connector, then at the tranny connector on the tranny.
    Good luck, the mark 3 transmission is notoriously finicky.

    Sep 11, 2013 | Cars & Trucks

    2 Answers

    Trouble code p0758 on a 2004 kia rio

    The solenoids are inside the transmission.

    Feb 23, 2013 | 2004 Kia Rio

    2 Answers

    I had code p0758 solenoid circuit B electrical

    Here is the definition of the code. You may need to have a transmission shop take a look at it.

    P0758 HONDA Description Shift solenoid valve B is turned ON or OFF by the Transmission Control Module (TCM) in response to signals sent from the park/neutral position (PNP) switch, vehicle speed and Engine Control Module (ECM) (throttle opening). Gears will then be shifted to the optimum position.
    Read more:

    Aug 15, 2012 | 1996 Honda Accord

    1 Answer

    O/d light blinks when driveing o/d seems to be engaged car has 198000 miles and runs very good also engine light is on

    O/D light blinks, but with that the check engine light is ON.--- This will make your troubleshooting easier.When the check engine light comes on, and remains on, this indicates that there is error stored in your cars computer.---- Once the computer is scanned, you will get error codes, as per that error code it will point towards faulty part, which is causing the O/D light to blink.-------- Most probably the O/D light blinks, If a problem exists in No. 1 or No. 2 solenoids or speed sensors .
    --------------- For car after 1995 it requires OBD2 tool and for car before 1995 it requires OBD1 tool.------- --------- You car will require OBD1 tool.There are very few auto parts store and repair centers who have OBD1 tool.In your case you required OBD1 tool.------ You can just contact local auto-parts store and they will guide you to the nearest store who has OBD1 tool.There you can get your car scanned.If there is error set in your cars computer, then you will receive the error code.As per error code it will point towards the faulty part causing this problem in your car.------------- -------------- The codes which you get is scanning will be mostly any of this following codes:--- DTC P0500 - Vehicle Speed Sensor Malfunction
    . DTC P0750 - Shift Solenoid "A" Malfunction
    . DTC P0753 - Shift Solenoid "A" Electrical Malfunction
    . DTC P0755 - Shift Solenoid "B" Malfunction
    . DTC P0758 - Shift Solenoid "B" Electrical Malfunction
    . DTC P0770 - Shift Solenoid "E" (SL) Malfunction
    . DTC P0773 - Shift Solenoid "E" (SL) Electrical Malfunction
    . DTC P1520 - Stop Light Switch Signal Malfunction
    . DTC P1705 - Direct Clutch Speed Sensor Circuit Malfunction
    . DTC P1765 - Shift Solenoid Valve SLN Circuit Malfunction
    . DTC P1780 - Park/Neutral Position Switch Malfunction
    --------------- Now it all depends on what code you get, as per that you can replace the following part.------- This will help.Thanks.Helpmech.

    Jul 07, 2011 | 1995 Toyota Camry

    1 Answer

    1997 Chevrolet Silverado Z71 p0758 Won't shift

    P0758 code is shift solenoid B electrical /2-3 shift solenoid circuit electrical, It better to inspect the wire going into the transmission they have a tendency to leak transmission fluid into the circuit make inspection for proper connection if you decide to replace the solenoid you still need to inspect the circuit for proper mating. If this solenoid fails and you wait to long to replace it you can loose the ECM due to the high power draw it takes from the ECM.

    May 06, 2011 | 1999 Chevrolet Silverado 1500

    1 Answer

    Code PO758

    P0758 Shift Solenoid B Electrical

    May 26, 2010 | 2003 Chevrolet Tahoe

    2 Answers

    My 2006 Chevy Avalanche's check engine light came on last weekend. We checked the fuses, the air filter and the gas cap. The light went out. Then my truck slowly exhilerated in drive. It's automatic. It...

    All these code's are to your transmission, your mech needs to do more then pull code's, he needs to look at date on sensor to transmission before opening.

    P0740 - Torque converter clutch solenoid circuit

    P0758 - Shift solenoid (B) electrical

    P0785 - Shift timing solenoid

    P0761 - Shift solenoid (C) performance or stuck off

    I would try Trans - X first pores right in to trans.

    Jan 15, 2010 | 2006 Chevrolet Avalanche

    Not finding what you are looking for?
    Cars & Trucks Logo

    1,745 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Chevrolet Experts


    Level 3 Expert

    76846 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22246 Answers

    Ronny Bennett Sr.
    Ronny Bennett Sr.

    Level 3 Expert

    6918 Answers

    Are you a Chevrolet Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides