Question about 1995 Nissan Pickup
You will have to remove some of the radiator hoses as they will block the access to one of the mounting bolts. Easy after that: remove the bolts, disconnect the wires.
Posted on Jul 03, 2009
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: 2005 Escape starter replacement
take the negative side off the battery put the car on ramps secure the rear end so it does not roll and if you need a diagram for removing and installing the starter try autozone
Posted on Jan 29, 2009
SOURCE: Brake drum 2005 Escape
here is a diagram on how to remove your brake drum. please do not forget to rate and comment about your experience with fixya today.
Removal & Installation
CAUTION Dust and dirt accumulating on brake parts during normal use may contain asbestos fibers from production or aftermarket brake linings. Breathing excessive concentrations of asbestos fibers can cause serious bodily harm. Exercise care when servicing brake parts. Do not sand or grind brake lining unless equipment used is designed to contain the dust residue. Do not clean brake parts with compressed air or by dry brushing. Cleaning should be done by dampening the brake components with a fine mist of water, then wiping the brake components clean with a dampened cloth. Dispose of cloth and all residue containing asbestos fibers in an impermeable container with the appropriate label. Follow practices prescribed by the Occupational Safety and Health Administration (OSHA) and the Environmental Protection Agency (EPA) for the handling, processing, and disposing of dust or debris that may contain asbestos fibers.
CAUTION Use of a brake drum puller or a torch is not recommended. Brake drum distortion can result.
NOTE If the brake drum is rusted to the axle shaft pilot diameter, tap the center of the brake drum between the wheel studs.
Drum brake exploded view
WARNING Whenever a wheel is installed, always remove any corrosion, dirt or foreign material present on the mounting surfaces of the wheel or the surface of the wheel hub, brake drum or brake disc that contacts the wheel. Installing wheels without correct metal-to-metal contact at the wheel mounting surfaces can cause the wheel nuts to loosen and the wheel to come off while the vehicle is in motion, causing loss of control. Failure to follow these instructions may result in personal injury.
Posted on Apr 16, 2009
They have kits to retrofit radios. Another thing that will cost is having the radio reprogrammed. Everything has theft lock on them now days. You would be better off to get a aftermarket stereo
Posted on Feb 27, 2011
Tips for a great answer:
Jul 24, 2014 | 2008 Ford Escape
Jul 15, 2013 | 2005 Ford Escape
Feb 27, 2011 | 2005 Ford Escape
Feb 22, 2011 | 2003 Ford Escape
Sep 16, 2010 | 2005 Ford Escape
Jun 17, 2010 | 2006 Ford Escape
169 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: