How to replace slave cylinder on rear brakes of 1400 Nissan LDV

SOURCE: rear brake cylinders are stuck, can not push them in

I have a 2004 SAAB 93 and just finished replacing the brake pads and rotors yesterday. On the piston itself you should have two little notches. You can either or a GM rotor reset tool that will push into the two little notches and push against the piston while rotating it clock wise. Or the way that I did it was to take a C clamp and put the caliper back on the car. Clamp it on the back of the caliper to the front of the caliper so it will remain stationary. Then take a pair of needle nose pliers and rotate the two notches clockwise while pushing into the caliper. It will take some strength but you should be able to push them in. Be sure that you spray the boot around the piston when some WD 40 so it does not crack and or break during the process. If you have any additional questions about this feel free to email me.

James
[email protected]

SOURCE: the removal of rear brake drums on a 1998 chevy k3500

You should be able to just pull them off! If they are stuck on you may have to get them off by beating on them with a small sledge hammer. Sounds primitive, but thats how its done at the shop. Just hit it straight on the front to break the rust loose. Whatever you do...don't hit the wheel studs. They aren't fun to replace.

SOURCE: how do I adjust emergency brake cable on 1999 ford

FIRST adjust rear brake starwheel while spinning tire FOWARD. then alongside drivers side of car find emergency brake cable adjustment (long threaded rod with nut) . hold one end of rod with vise-grips and turn nut until emer. brake cable has less slack in it. now go inside car and apply e-brake.you dont want the pedal to stop right away but u also dont want too much"travel" in the pedal.so about halfway is IDEAL. IMPORTANT- once the brake cable is adjusted and the car wont roll foward in gear with the brake on and applying a little "gas"-make sure with brake OFF that rear wheels turn freely. hope this helps.

SOURCE: replace rear brake shoes on 1999 nissan altima and

if the orginal drums there might be a lip of rust and metal buildup that needs to be cleaned off. try also backing the adjuster off to allow the drum to go over the shoes, do the shoes look the same as the old ones, just more materal? Don't forget to adjust the shoes back to the drum so you gte a good pedal feel, and the rear brakes will work properly

SOURCE: 1999 Chevy Tahoe- Soft Brake Pedal

Try having the dealer flush and bleed your system. It is very hard to bleed ABS systems yourself and have safe brakes that still work afterward. Bleeding non-ABS brakes yourself is easy not the same for ABS brakes. Valving, sensors and what-not require a tech and the correct equipment in my opinion. You do it wrong and you could ruin your ABS system. Do that and see if they firm up. I replaced my brake shoes/pads at the same time all new everything in back, drums/springs everything and new rotors up front. then I had the chevy dealer flush, refill and bleed system. Stiffer pedal and brakes work better. Keep in mind the brakes on 99 Tahoes are inaedequate, require new rotors often, heat up and fade/glaze pads regularly. I replace my pads long before they wear down because they glaze up and start fading early. I'll rough em up once maybe, next time, new ones. Every two brake jobs, new rotors for me. Just how it is. They will stiffen a bit and work better but they will never be awesome brakes. Just how it is on 99 and earlier Tahoes. Hope it helps. Very important to bleed correctly though. I'll bleed my 83 Toyota 4x4 myself but not the Tahoe.