How to reset a airbag light on a firebird

Fourth Question, same car as last question.

You reset it with the same Scan Tool that you use for the vehicle engine check light.

you may have a failing or intermittent Toyota 4runner 2005 passenger occupant sensor for air bag Perhaps you need to take it to Toyota

https://resetservicelight.com/reset-srs-airbag-warning-light-toyota-4runner-fourth-generation/

How to adjust clutch??? 95 bird. - Fourth Generation Pontiac ...

www.firebirdnation.com/forums/.../65178-how-to-adjust-clutch-95-bird/
Dec 5, 2008 - posted in Fourth Generation Pontiac Firebird (1993 - 2002): I have ...Year: 2000; Make: Pontiac; Model: TRANS AM; Engine: 5.7L LS1; Transmission: MANUAL 6 SPEED T-56 ... Have you looked at your clutch master cylinder. Throttle is sticking after acceleration - Fourth Generation ...
Oct 7, 2011
1 Problem / Few questions - Fourth Generation Pontiac Firebird ...
Mar 26, 2010
Firebird Technical Service Bulletins - Fourth Generation Pontiac ...
Jul 5, 2006
TECH ARTICLE MASTER INDEX Look Here - Firebird Nation
Aug 18, 2004
More results from www.firebirdnation.com

How to Install Clutch 98-02 LS1 F-Body Part 1 of 2 - YouTube

? 12:31
www.youtube.com/watch?v=4BCHu2BwBMs

Apr 12, 2013 - Uploaded by MapleBoarder78
Part one of installing a new clutch on my 2000 Trans Am. Part 2 will include installation ... How to Master Cylinder Install and Drill Mod (LS1 F-Body) - Duration: ... 6:28. Removal and Servicing ofClutch Master Cylinder to Slave Cylinder ... LS1 98-02 Chevy Camaro Z28 SS Pontiac Firebird Trans Am F-Body ...

If the airbag light is on, there is a failure in the airbag circuit, and your airbag may fail to deploy in the event of an accident.
There is no "reset." You will need to have your airbag system serviced.

the MAP sensor has a short to ground problem so I would consider replacing it and checking the wires and connections.

i need to remove steering wheel on 1996 firebird to check dimmer switch rod

Obviously the computer in you car does not sense the airbag. It could be something simple like a bad connection or something major where the propellent or gas generator in the old airbag is faulty. In any event your system will not deploy so you should recheck your wiring and if that doesn't fix the problem, the airbag should be replaced.

Ive worked at a Toyota Dealer for the past 11 years and yes this is normal. Nothing to worry about. Everything is working properly

When the airbag light is on it means a fault has occurred in the system and the airbag diagnostic monitor has disabled the system, the most common problem that turns the light on is a break in the connection to the steering wheel mounted airbag, this is due to a rotating ribbon contact that breaks under the steering wheel that connects the airbag to the wiring harness and the diagnostic monitor, the part is called th clock spring contact, a coiled up ribbon electrical contact that turns with the wheel

On both lower frame rails behind the headlights. You need to remove the front bumper to gain access to them. On the out side of the frame rail about 12 to 15 inches back.