Question about Toyota Tercel

1 Answer

94 toyota camry has check engine light on and it will looses power and shuts off diagnostic shows a code of P1600 - any suggestions

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Toyota Master
  • 14,036 Answers

P 1600 is ecm batt malfunction.

Posted on Jul 03, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Can a diagnostic connector on 1995 Toyota 4 runner be jumped over with jumper wire to get check engine codes?


There is probably a way to access codes by using a jumper and causing the engine checklight or an integral led to flash in groups. I can't say which pin or pins need jumping.

I suggest you ask the question of google and click on the youtube video.

Jun 26, 2016 | 1995 Toyota 4Runner

1 Answer

Toyota Camry engine vibrate on stop,and shutting off


check engine mounts there mite be a loose or broken one, works fine while driving but is a problem when starting and stopping

Aug 16, 2014 | 2004 Toyota Camry

1 Answer

Have a 94 toyota camry , check engine light comes on when stop at light or car sits at idle. got codes 12 , 22, am very confused !!


Code 12. RPM signal.
Problem area: Loose connection, broken rpm signal wire from distributor to ecm to rpm meter, rpm meter, distributor assembly or ecm defective.
Code 22. Water temperature signal.
Problem area: Loose connection at water temperature sensor connector, broken wire between the sensor and the ecm, defective sensor or ecm.

Aug 25, 2013 | 1994 Toyota Camry

1 Answer

Hey hey!! my check light comes on and starts to flutter and so does the engine! eventually loosing all engine power and it wont even drive??? please help if u know what i mean??? (the orange check light in...


These engines have a self-diagnostic system built in. Find a manual on how to engage this self-diagnostic - you jump a couple of leads in a junction box and then count the number of times the check engine light blinks in succession. Refer to the Toyota manual for identifying what system is affected. Sounds like a critical component is out - fuel pump perhaps. Don't quess - use the diagnostic system.

May 13, 2010 | 1989 Toyota Camry

1 Answer

94 Camry was running fine, suddenly became sluggish


How did you try to obtain the codes? Did you short pins E1 and Te1 in the grey connector under the hood?

When the light comes back on, short the above pins, and get back to us.

Without seeing the codes, I would venbture a guess that you first consider a good tune-up, and use Toyota plugs only. Any other manufacturer will not work very well. I see this every day, new plugs, and the engine runs poor. Toyota plugs fixes it right up. The heat ranges are diffferent in Toyota plugs.

Nov 03, 2009 | 1994 Toyota Camry

2 Answers

Noise in sway bar area/94 camry 4 cyl


Possible tranny or engine mount. Check bushings. Check brake pad backing plates (loose), check brake pad movement (add shims), but most likely mounts. you need to torque the engine while an assistant checks for bad mounts.

Aug 31, 2009 | 1994 Toyota Camry

2 Answers

94 Toyota Camry has rough idle.


check for a small vacuum leak speciallythe lines going to the throtle have someone look at it while you seat onthe car , idle ,FOOT ON THE BRAKE ! a way to test for leaks if to spray a lil wd40 around the lines an listen if the idle gets better or worst, sometimes the reason the engine runs to rough or lean are vacumm lines that are slightly broken.

May 28, 2009 | 1994 Toyota Camry

2 Answers

2003 toyota highlander OBD code's po442/po446/po441


if the air filter was recently inspected or changed, look for the vacuum hose to be disconnected from the valve located on the air filter cover. another source may be the gas cap either loose or with the tether strap caught under it preventing a proper seal

Dec 20, 2008 | 2003 Toyota Highlander

1 Answer

Orange check light on what does it mean cant tell what the symbol is?


The orange check light is the Check Engine light. This comes on when you have something wrong with the systems/sensors that are controlled by the vehicle's computer. The Check Engine light comes on for a myriad of reasons, the number one culprit is a loose fuel filler cap. What I would suggest to you is to take your car to an Autozone or somewhere where you could get a scanner plugged into your car's diagnostic connector, and get the reason for the light being on identified. Once you have the trouble code, you can get back to me for additional info to rectify your situation!

Oct 10, 2008 | 2001 Toyota Camry

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

688 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8215 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...