Question about 2000 Ford Windstar

1 Answer

Today my ABS light and brake light stayed on with

Today my ABS light and brake light stayed on with the O/D light flashing. And the A/Cwent out? But still drives. What could it be?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 58 Answers

Low brake fluid

Posted on Jul 05, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My dashboard lights (battery emergency brake light & air bags) are flashing on my dashboard while driving but go out when I come to a stop on my 2001 santa fe


Whenever this warning light or any other stays on in the dash it is indicating that the systems control module (or the system sensor in the case of lights like low oil pressure, door open indicators etc.) has detected a fault, it then disables the system (this applies to ABS,TCS, TCM, SRS and BCM faults and others) as long as the light is on. You must now have the dealer hook up a special electronic diagnostic tool and "scan" the system for the fault code that is stored for the problem(s)

Legend of Abbreviations. ABS Antilock brake system.TCS Traction control system, TCM Transmission control module, SRS Supplemental restraint system, BCM Body control module

Oct 17, 2012 | 2001 Hyundai Santa Fe

1 Answer

Abs light stays on and brakes hard to push


Abs which stands for anti brake system has failed. In most cases replacing the control senor for abs will fix the problem. Where it is located on your car i dont know . Call your local autozone and they will help you out... Hope this helps and Please rate this post.

Aug 14, 2012 | 1992 Dodge Dynasty

1 Answer

Ive just bought my audi a4 S.E 1.8 petrol 1998.. with 164k...when i bought it the abs lightt was on and also the brake warning indicator light comes on and stays on flashing,and at the same time the abs...


as the mot only says the "brakes work"to a certain efficiency,(the tester does NOT check the depth/thickness of the pads),chances are your pads/discs are in need of replacement.the pads have sensors in them for wear depth, so when checking the pads,front AND rear the abs sensors can be cleaned,and if done by a seat/skoda/vw/audi dealer they can put it on the diagnostic computer to give you a definative answer (this is cheaper than guessing) I replace the pads myself but get the car "diagnosed"when any red light shows.

Jan 31, 2011 | Audi A4 Cars & Trucks

1 Answer

Abs light on anf off after rear brake job. Today


Not a booster problem. what bad noises? abs problmes wont make noises, unless its the pump operating. ck the mushy pedal, that will maybe fix all problems. I dont think its related to the 2/4wd lights?

Jul 23, 2010 | 2000 GMC Jimmy

1 Answer

Abs light stays on ol the time olso hand brake


My 2000 passat does the same thing... I was told i need to replace my abs pump... but Ive been driving it this way for eight months with out any known problems... i was told it just wount pulsate the brakes for you... you need to do it old school and pump the brakes in an emergancy

Nov 18, 2009 | 1998 Volkswagen Passat

1 Answer

Brake light on vehicle lit up on dash


check the parking brake sometimes a slight bump can make that light come on... pull it up then disengage it roll the car back and forth and see if it goes out.. 2nd make a heavy salt and water solution and completely drench the brake calipers with it move vehicle back and forth working brake...then spray off immeaditaly with a hose... this should clean up the abs sensors... if ithe light still stays on it may be a malfuction in the cars obds ( on board diagnosis systems..) unpluge positive termianl from your car let it set off for like 3 mins then put it back and start car see if the light stay on after you take it for a drive... if none if these work take to your dealer ship to replace the abs sensors... it wont be cheap....

Good luck.. Hope it fix's'ya!!

May 19, 2009 | 2001 Chevrolet Blazer

1 Answer

Abs light stays on/strong smell


Check the E-Brake, make sure that the ebrake is not engaged and that it is fully disengaging. If that is not the problem, then there is something with the brake calipers or rotors that are not allowing your brakes to fully disengage

Apr 30, 2009 | Mazda MPV Cars & Trucks

1 Answer

Abs brake light stays on


There is no ABS brake light. Take the vehicle back to whatever service center/garage did the brake work and tell them to fix it.

Apr 05, 2009 | 2003 Hyundai Santa Fe

2 Answers

Shows ABS fault on dash and ABS light stays on


Check your abs connectors they might have pulled a wire loose

Nov 11, 2008 | 2004 Chevrolet Colorado

Not finding what you are looking for?
2000 Ford Windstar Logo

Related Topics:

283 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

fordexpert

Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...