Problem for Oldsmobile Cars
Generic problem for all Oldsmobile Aurora Cars
Where is the oil pressure sensor on a 2001
Where is the oil pressure sensor on a 2001 Oldsmobile Aurora with a 3.5 V-6
Best Solution
posted on Jul 03, 2009
Rank: Guru

Expert
Rating: 93%, 1303 votes
The oil pressure sensor is between the exhaust manifold and oil filter. You can get to it better from the bottom by removing the oil filter to give you more room and it should take you under 30 min to replace oil filter and all. I guess if you have long thin arms you can get to it from the top too. Good luck and hope this helps.
Was this helpful?2 people thought this was helpful
Popular Solutions for Cars
Questions and Unsolved Problems for Cars
why does the ecm/batt fuse keep blowing
The temperature controller slide will not allow the heater valve to open all the way to allow the...
(More)
The temperature controller slide will not allow the heater valve to open all the way to allow the heated water to circulate through the heater core. How do I take the front of the dash loose to access the controller to adjust the cable or rod housing on a 1993 Dodge Caravan?
I want to replace the ring gear and pinion in my 1968 Camaro with a 12 bold rear end. It has 373...
(More)
I want to replace the ring gear and pinion in my 1968 Camaro with a 12 bold rear end. It has 373 ratio now but the rear end code said it had 410 ratio. I want to change the ratio to 410.
engine surges while holding accelerator steady, all vaccum hoses are connected, problem didnt occur...
(More)
engine surges while holding accelerator steady, all vaccum hoses are connected, problem didnt occur until after i had pressure washed the engine
how to insatall a starter