Question about 2003 Land Rover Freelander

2 Answers

I have a water leak under the intake manafold

Posted by on


2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert whose answer gotĀ voted for 20 times.


    An expert who has answered 20 questions.

  • Expert
  • 61 Answers

Try changing intake and plenum gaskets.. Not to hard.. If you can get a haynes manual to help you with dis and reassembly. Not terribly hard to do..

Posted on Jul 03, 2009

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Another common problem with the Freelander (w/6 cyl gasoline engine) is the failure of O-rings on the thermostat assembly. Replacing these can easily cost $500 to $700. The engineers who designed? this engine should return their degrees to their local high school, be fired from LR (or sent back to the mail room) and seek forgiveness from owners. IMHO

Posted on Aug 28, 2009


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 80668 Answers

SOURCE: water leak on top of engine of a 1995 town car

I know this darn hose, u have to pull the intake to replace it, we used the factory hose but you can use any type of water/coolant rated hose in that size.

Posted on Jan 02, 2009

  • 140 Answers

SOURCE: Exhaust leak back side of 1992 ford f150 302 v8 engine

its the exhaust manafold gasket or the donut gasket in the exhaust pipe, proably the donut gasket.. its a part you can pick you for about $15.. good luck keith...

Posted on Mar 21, 2009

  • 6674 Answers

SOURCE: water leak from under dash

There should be one under hood on passenger side, sticking out of firewall that may be plugged up. Take a piece of coated wire or similar and stick it up in there and see if it's plugged & clean it out, but be careful, don't jamb it too hard & poke a hole in anything like heater core back in there. If it's plugged, it will sometimes back up into interior of vehicle.

Posted on Apr 28, 2009

  • 1055 Answers

SOURCE: engine cranks manafold intake back fires

you have a cracked dis cap give it a complete tune up
of that doesnt help your timing gear needs replaced!!!!!!!

Posted on May 26, 2009

  • 1 Answer

SOURCE: water leak under the intake manifold,1995 toyota 4 runner

There is a heater core bypass pipe that runs from the block (under the manifold) to the bacl of theengine where you will see a flat rectangular "sheet metal" thing with a pipe coming out of it. The a rubber hose connects. You need to pull the top air plenums and intake to get to it. The p[ipe flange bolts to the block with silicone rtv as a sealant.

Posted on Nov 27, 2009

Testimonial: "thanxs"

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Hi I have just rebuilt a 4.3L in a 1998 GMC Jimmy 2whell drive and it is leaking oil out of the intack manafolds builts why

If the intake is not properly put into place, oil can leak out of the ends. Use new gaskets, and silicone on the corners (2 front) (2 back). spray the gaskets with red tacky sealer, torque the intake, and make sure there is no cracks under the intake (on the bottom of it). Also if you machine too much off of the heads when you resurface them the intake may have to be machined as well. I hope this helps.

Jul 12, 2015 | GMC Cars & Trucks

1 Answer

1996 gmc jimmy loses power in 3rd gear

Failure to shift is almost always an internal transmission problem. For the water problem, probably a small leak in a cooling system hose or hose connector running near the intake manifold. The leak will probably only be found when the system is under pressure (i.e. engine hot and running).

Jul 30, 2017 | 1996 GMC Jimmy

1 Answer

Water leak on intake manafold

Check that the rubber hood gasket is in good shape, and fully on the metal seam. This is seen when the hood is open, it is by the wiper cowl.

Jul 14, 2010 | 2001 Ford F150 Styleside SuperCrew

1 Answer

My blazer started this morning but was leaking antifreeze on the ground. I don't think its the water pump. could it be the intake manafold gasket? it seems to be leaking at the front of the intake.

It would either be the intake gasket, thermostat housing gasket,upper hose at the thermostat housing,or the heater hose that enters the intake.

Feb 09, 2010 | 1999 Chevrolet Blazer

1 Answer


stop driving and check the oil if it looks like light coloured chocolate milkshake get it towed to a repair shop and have it redone.good luck

Mar 23, 2009 | 2002 Dodge Intrepid

1 Answer

Exhaust leak back side of 1992 ford f150 302 v8 engine

its the exhaust manafold gasket or the donut gasket in the exhaust pipe, proably the donut gasket.. its a part you can pick you for about $15.. good luck keith...

Mar 21, 2009 | 1992 Ford F150 SuperCab

1 Answer

Trying to work out which hose has a leak

not enough infomation to give you a it a fuel line hose! is water leaking.! is you engine missing form a vacume hose! it might be a fule injector line or a return hose for fluid transter. be more pacific thanks..

Oct 07, 2008 | 1994 Mazda MX-3

Not finding what you are looking for?
2003 Land Rover Freelander Logo

217 people viewed this question

Ask a Question

Usually answered in minutes!

Top Land Rover Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

80668 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Land Rover Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides