Question about 2003 Ford Ranger Regular Cab

1 Answer

Radio on 03' ranger edge does not come on

Clock lights up but no radio on, what could this be

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert whose answer got voted for 500 times.

  • Master
  • 1,129 Answers

Check the antenna wire in the back of radio

Posted on Jul 03, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Which fuse to change for steering wheel lights and gear shifter lights 2010 ford edge

It's not a fuse , the SJB - smart junction box controls these lights ! This is fords body control module . If the Heater / A/C control panel ,hazard switch ,headlamp switch , message center switch all work, it is not a fuse . The gear shifter I would say the bulb is burnt out . The steering wheel lights could be out because of an open in the clock spring . The clock spring is a device inside the steering column under the steering wheel that keeps your horn , cruise control , radio buttons etc... connected electrically . How cars clock spring works

Feb 04, 2016 | 2010 Ford Edge

1 Answer

How to set radio clock on a 1994 ford ranger

How to set the clock


Turn the radio on.


Press and hold the "CLK" button, press the right (a) side of

the "SEEK" button to increase hours. Press the left (

b) side

of the button to decrease hours. Press the right (

a) side of

the "TUNE" button to increase minutes. Press the left (


side of the button to decrease minutes.

NOTE: The clock displays 12-hour time with no AM/PM

Jun 05, 2012 | Cars & Trucks

1 Answer

03 bonneville clock light does not work

I have a 2005 Bonneville. This is a common Pontiac problem.
There are 3 bulbs in the radio behind the clock display. All three are probably burned out.
You can have the dealer replace the radio. $400-500?
Or send the radio out for repair. For example see $200-300?
Or try to fix it yourself. I fixed mine, but it can be complicated. Can you solder? I did a write-up at this website:
You may have to register first, and/or search for "radio display bulb"
Here's a couple pictures.



Aug 25, 2010 | 2003 Pontiac Bonneville

1 Answer

Ford ranger 1998. no illumination readout for channels and clock.other lights work on radio.iS THIS REPAIRABLE?

Please don't take this as an insult, but have you adjusted the dim switch that you can adjust the brightness of your dash lights? I have a wheel on my dash that you can turn up or down the brightness and right after I get to the brightest is turns on the dome light. Are you sure this is not your issue?

Good Luck

Oct 08, 2009 | 1998 Ford Ranger SuperCab

1 Answer

My truck starts most of the time but has failed to turn over twice in 2 dats but then evetually will this a clogged injector or pressure regulator..03 ranger edge

The typical symptom of problems with the injector are, stalling , hesitation and fouling of spark plugs. You should even see the spark plugs wet with gasoline. Otherwise check the status of the spark plug if it needs replacement or even the timing.

Aug 26, 2009 | 2007 Ford Edge SEL Plus

1 Answer

'03 Suzuki XL7 clock/ swithced 12v circuit won't work

try under the dash board on the driver side..should be a 15 amp...

Aug 11, 2009 | 2003 Suzuki XL-7

1 Answer

My 2002 Ford Ranger Edge brake lights do not work

Brake light switch It is on the brake pedal

Jun 29, 2009 | 1987 Ford Ranger

1 Answer

03 ford ranger edge stalls with ac on only

your idle engine speed is set too low. there is a idle speed screw on your carb if it is a carb model or on your throtle body

Mar 06, 2009 | 2003 Ford Ranger Regular Cab

1 Answer

03 Accd Cpe EX 4c - control lights on steering wheel do not work

sounds like you have a problem in your clock sping or your lights just burned out

Nov 11, 2008 | 2003 Honda Accord

Not finding what you are looking for?
2003 Ford Ranger Regular Cab Logo

Related Topics:

78 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

5687 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides