Question about 1984 Chevrolet Corvette

1 Answer

My digital dash blacks out in my 84 vette. - 1984 Chevrolet Corvette

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 291 Answers

THEY HAVE A COMMON PROBLEM WHERE THE POWER SUPPLY MODULE ATACHES TO THE MAIN BOARD.. THEY GET COLD SOLDER JOINT AND NEED TO BE RESOLDERED.AFTER REMOVING THE BACK BOARD AND CLEANING THE CONTACTS ON THE PINS THAT ELECTRICALLY ATTACH THE TWO BOARDS... YOU THE CAN LOOK FOR A SMALL BOARD THAT IS SET OFF FROM MAIN BOARD.. JUST RESOLDER ALL THE SOLDER JOINTS ON PIN IN AND OUT OF MODULE

Posted on Sep 01, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

84 vette has draw on battery won't start in morning


Alternator, starter, radio or interior lights. Main four things that draw power for 84's Could also just be a bad battery.

Apr 04, 2015 | 1984 Chevrolet Corvette

1 Answer

My 84 vette emits a dark smoke from the exhaust but only does it part of the time. Sometimes it doesn't smoke at all and sometimes it smokes a lot. Any ideas on what it could be?


dark smoke is unburned fuel or incompleat burning ,start by looking over ignition ,air cleaner, coil , distributer cap ,rotor , plugs ,wires,

Feb 15, 2015 | Cars & Trucks

1 Answer

Dash board on vette 2005 little ligth bulb


its not a bulb,its the temp sensor,just leave it alone

Jan 11, 2013 | 1996 Ford Taurus

1 Answer

84 vette, how do I remove power steering pulley to get the pump out?


Usually you have to take a pulley puller kit and just pull the pulley off the shaft. Installation is reverse, you use a threaded stud in the shaft to pull the pulley on with.

Jul 24, 2012 | 1984 Chevrolet Corvette

1 Answer

84 vette no power to dash instruments sometimes get a partial read on tach


I have worked on lots of chevy's for this problem and all it is , is the plug to the instrument panel. Usually unplugging it and plugging it back in solves this problem. On occasion I would have to secure it in better, by bending the leads, and this depends on the model. I cant tell you how to get it out, but all that I have done aren't that difficult. Hope this helps you.

Mar 06, 2011 | Chevrolet Corvette Cars & Trucks

1 Answer

I have an 84 vette and cannot switch from vent to defrost or heat, it only stays on vent at all times can u advise please ? smoke in Deetroit


First, check that the vacuum line from the engine going into the dash is connected and not leaking. Then, check for vacuum at the control head. If there is vacuum there, check the vacuum "motors" on the heater box. If they have vacuum and fail to operate then the diaphragm inside the non-moving one has failed and the motor needs replacement.If motors are not getting a vacuum signal back up to the control head. The control is bad.

Oct 28, 2009 | 1984 Chevrolet Corvette

1 Answer

Taillight lense removal on 84 vette


If I remember you need to remove them from laying on the ground and going in from under the car behind the bumper. Some models did have 2 screws on the front the older ones had to be removed from behind the bumper.

May 24, 2009 | 1984 Chevrolet Corvette

2 Answers

How to remove the top for open effect


there are 4 bolts holding the 84 vette top on. two front two rear. There are holes in the top from the inside 2 behind the visors and two at rear. Wrench looks like an allen wrench. There is a tool for the removal which is usually stored in the glove compartment between the seats.

Apr 26, 2009 | 1984 Chevrolet Corvette

1 Answer

84 vette aready changed ECM coil plugs wires map sensor fuel pump and filter and cleaned out gastank but cant get to run i think it is limp home mode but dont know how to fix


This may sound odd, but did you rermember to keep your "PROM" from your original ECM? It is the memory for all the ECM codes and configuration. The new ECM normally doesn't come with a PROM.














Oct 12, 2008 | 1985 Chevrolet Corvette

1 Answer

Turn signal/ Emergency Flasher


yes happens all the time.  I've had to replace mine like many other vette owners.  Order it from gmpartsdirect.com and search vette forums for how to replace hazard switch.  You should find the directions on how to replace it without taking apart the whole dash.  Not very diffiecult.

Aug 11, 2008 | 2000 Chevrolet Corvette

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

244 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...