Question about 2001 Nissan Frontier Crew Cab

2 Answers

Air Conditioning blows on 4 but not 1,2, or 3. I was told there is a resistor to replace but where is it? Also do the filters need replacing?

Posted by on

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

The resistor is located in the passanger side floorboard built into the vent ducting close to the blower motor. There is 4 wire connector (wires are in a row [- - - - ] ) to it and has 2 screws holding it in. Buy the resistor (they're cleep) and look at the back you'll find it easy then.

Posted on Aug 08, 2009

Ad
  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 146 Answers

The resistor is located near the blower motor.

Posted on Jul 28, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2003 Ford Explorer HVAC blows weak, blend door motor and blower motor resistor already replaced


is the cabin air filter plugged up and it's not getting any air to blow?

Jul 10, 2012 | 2003 Ford Explorer

2 Answers

All air stopped blowing in through the vents.


o air coming from air conditioning vents
  1. Check the air conditioner fuse and replace as necessary.
  2. Air conditioner system discharged. Have the system evacuated, charged and leak tested by an MVAC certified technician, utilizing approved recovery/recycling equipment. Repair as necessary.
  3. Air conditioner low pressure switch defective. Replace switch.
  4. Air conditioner fan resistor pack defective. Replace resistor pack.
  5. Loose connection, broken wiring or defective air conditioner relay in air conditioning electrical circuit. Repair wiring or replace relay as necessary.

Apr 27, 2010 | 1986 Toyota Camry

1 Answer

Heater works only on level 4 or 5 same for air conditioning told its a resistor problem where is it located and is it a resistor?


CHECK THE BLOWER RESISTOR AND THE CONNECTOR. THEY TEND TO BURN TOGETHER.

THE RESISTOR IS NEAR THE BLOWER ON THE PASSENGER SIDE OF THE TRUCK.

A DEALERSHIP USUALLY CARRIES BOTH PARTS AS THIS IS A COMMON PROBLEM.

Nov 23, 2009 | Chevrolet Silverado 2500 Cars & Trucks

5 Answers

2004 Honda Accord Air Conditioner Not Working


Sorry for the delayed response. For future reference, the blower motor resistor in an 04' Honda Accord is located under the glove box and a little to the left if you are facing it (the glove box). You just need to pull out the plastic panel (yes, you can just pull it out by hand, no tools needed for that). It should be right on the fire wall with a plug going into it. If you reach in there and pull the plug (it has a little notch so it clips into the resistor more securely; make sure you push the clip in) it should have 4 flat prongs on it that go into the resistor. The resistor itself will have 2 phillips head screws that are holding it into the fire wall. Unscrew them and you have the resistor. If you can unscrew both screws before unplugging, it will be easier to see how it unplugs. I know this sounds complicated but once you get in there you will notice it's fairly easy to change out.

May 15, 2009 | 2004 Honda Accord

1 Answer

Difference between an Air Filter and Air Conditioning filter


The air conditioning filter that your manual speaks of is known as a ''cabin filter'', it is much differant then your engine air filter. It filters the incoming air into your vehicles interior. So if someone has told you to replace your ''air filter'' they are more then likely speaking of your ''engine'' air fitler. You should check your engine air filter every oil change. If it shows signs of dirt, then replace it. Hope this helps =)

Mar 12, 2009 | 2003 Toyota Land Cruiser

5 Answers

The air conditioning,the blower fan everything stopped working, on 2002 Nissan Sentra. Does anyone have any suggestions?


One suggestion. Have you checked the fuses ?

I would check the AC or blower fuse to start with. If you have the drivers manual it will show you where the fuse box is. Typically there are at least two boxes to check. One in the Engine compartment and one in the passenger cabin.

Look inside the lid of the fuse box to see which fuse may apply to the AC circuits or the blower and check to see if they are blow. the metal link between the two posts that plug in. If the link is missing you need to replace the fuse with one of the same rating. Make sure you know where you took the fuse out from and put it back in the same slot if its good. Check all the main fuses if possible to see if any have blown and replace if they have.

Aug 12, 2008 | 2002 Nissan Sentra

2 Answers

2002 Aztek Bllower resist


no, did you replace the passenger cabin filter? chance are it is to late...i just found out today it is best to bc it puts pressure on the blower....its in the glove box..

Aug 03, 2008 | 2002 Pontiac Aztek

Not finding what you are looking for?
2001 Nissan Frontier Crew Cab Logo

162 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

80339 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...