Abs light code 1 has new module and pump motor

Have it checked for DTC'S - diagnostic trouble codes . ABS and brake light on , codes are stored in the EBCM - electronic brake control module . Could be ABS relay , control module , pump motor and the only way to find out what the problem is , have checked for DTC'S

The ABS EBCM anti-lock brake module is failing causing problems with the ABS pump running constantly, also will drain your battery.

1. Remove the ABS fuse to prevent ABS motor burn out.
2. You can still drive your vehicle with the module removed.
3. We recommend covering the exposed surface of the hydraulic control unit with aluminum foil to keep out water and dirt.

Common Failures:

• ABS Pump Always Running
• Codes: C0265, C0267, C0268
• Pump Motor Circuit trouble code
• Power Relay trouble code
• Valve Relay Trouble code
• Dump Valves (solenoids) trouble codes
• No Communication
• Intermediate power loss

http://www.myairbags.com/dtc-code-c0265-abs-ebcm-light/

When a pump code comes on for the abs it is usually associated with the module connected to the pump. Most of the time either the relay controlling power to the pump loses it's continuity on the board or the connector builds corrosion and resistance in the terminals. Most of the time depending on the make and model an the exact code it can be remedied by purchasing a new or used abs module/ pump, repairing the old module/ pump, or just replacing with a new module/ abs pump(most expensive option). It is very common for abs relay/ pump codes to appear and end up relating to the power or ground circuit going to open( breaking continuity it frying a connection form resistance)

ABS LIGHT AND MODULE TROUBLESHOOTING:

Anti lock brake system light comes up when there is issue with car brake systems. It can be low brake fluid or faulty ABS fuse or its issue with brake system or assembly. Your vehicles brake system needs inspection.

To troubleshoot these issues, I suggest you to refer the help links provided below. There are direct links with accurate solution, for these specific issues.

Click the link below and follow the procedure: ------

All types of ABS LIGHT / brake problems and repairs

http://howtobyme.blogspot.com/2011/11/abs-and-service-light-comes-on.html

-------------------

ABS light stays on but brakes work fine?

http://howtobyme.blogspot.com/2011/11/abs-light-stays-on-but-brakes-work-fine.html

----------------

VCS and ABS lights go on and off intermittently on Lexus?

http://howtobyme.blogspot.com/2011/11/vcs-and-abs-lights-go-on-and-off.html

-------------

The ABS and Traction Control Lights stays ON dash of car?

http://schematicsdiagram.blogspot.com/2011/06/abs-and-traction-control-lights-stays.html

-------------

ABS & Brake lights warning indicator steady on dash and speedometer not working for Dodge Ram?

http://howtobyme.blogspot.com/2011/11/abs-brake-lights-warning-indicator.html

-----------------------

Battery Light and ABS Light on Dash

http://whoisbyme.blogspot.in/2012/07/battery-light-and-abs-light-on-dash.html

-------------

Sometimes ABS light comes on while Driving?

http://howtobyme.blogspot.com/2011/12/sometimes-abs-light-comes-on-while.html

-----------

How Anti-Lock Brakes Work?

http://technoanswers.blogspot.com/2011/11/how-anti-lock-brakes-work.html

-------------

Brake System Troubleshooting?

http://technoanswers.blogspot.com/2011/11/brake-system-troubleshooting.html

-------------

Anti-lock brake light stays on all the time?

http://technoanswers.blogspot.com/2012/01/anti-lock-brake-light-stays-on-all-time.html

-------------------

ABS light comes on and Car makes Grinding noise?

http://repairhelpcenter.blogspot.com/2012/01/abs-light-comes-on-and-car-makes.html

---------------

ABS trouble codes for all models?

http://repairhelpcenter.blogspot.com/2011/11/abs-trouble-codes-for-all-1994-00-acura.html
------------

2008 Toyota Highlander: ABS warning light Blinking and OBD Error codes Coming?

http://technoanswers.blogspot.in/2012/05/2008-toyota-highlander-abs-warning.html

--------------

2003 Lexus ES: VSC, TRAC OFF, ABS lights ON?

http://technoanswers.blogspot.in/2012/04/2003-lexus-es-vsc-trac-off-abs-lights.html

----------------

2008 Toyota Highlander Hybrid: Warning Lights Abs, Vsc & Brake Are On?

http://technoanswers.blogspot.in/2012/04/2008-toyota-highlander-hybrid-warning.html

-------------

ABS & Brake warning lights remains steady on dash?

http://schematicsdiagram.blogspot.com/2011/12/abs-brake-warning-lights-remains-steady.html

------------

Can I drive the car without ABS fuse connected?

http://schematicsdiagram.blogspot.in/2012/02/can-i-drive-car-without-abs-fuse.html

-----------

Where is ABS/TCS module located on 2005 Cadillac Deville

http://schematicsdiagram.blogspot.com/2011/12/where-is-abstcs-module-located-on-2005.html

------------------

ABS motor keeps running?

http://schematicsdiagram.blogspot.com/2012/01/abs-motor-keeps-running.html

------------

When the car stops, abs pump turns ON?

http://howtobyme.blogspot.com/2011/12/when-car-stopsabs-pump-turns-on.html

-----------

Replacing ABS unit on Buick Century?

http://technoanswers.blogspot.in/2012/02/replacing-abs-unit-on-buick-century.html

----------------

2008 Toyota Tacoma: ABS causes Brake pedal fade?

http://technoanswers.blogspot.in/2012/04/2008-toyota-tacoma-abs-causes-brake.html

--------------

Toyota Camry: Premature ABS Actuation?

http://technoanswers.blogspot.in/2012/04/toyota-camry-premature-abs-actuation.html

-----------

How to replace ABS Modulator Control Unit on Acura Integra?

http://repairhelpcenter.blogspot.in/2011/11/how-to-replace-abs-modulator-control.html

----------------

How to replace ABS Pump Assembly on Acura Integra?

http://repairhelpcenter.blogspot.in/2011/11/how-to-replace-abs-pump-assembly-on.html

-----------

How to remove ABS Accumulator on Acura Integra?

http://repairhelpcenter.blogspot.in/2011/11/how-to-remove-abs-accumulator-on-acura.html

---------

How to remove ABS Control Unit on Acura Integra?

http://repairhelpcenter.blogspot.in/2011/11/how-to-remove-abs-control-unit-on-acura.html

------------

These details will help.

Thanks.

B1596 ABS Module Service Continuous Codes NOTE: If other DTCs are present, REPAIR them before installing a new component.
TURN the ignition switch to the OFF position and wait at least 30 seconds. Turn the ignition switch to the ON position. REPEAT the ABS self-test. If any DTCs are retrieved, REFER to the Anti-Lock Brake System (ABS) Module Diagnostic Code (DTC) Index. If no DTCs are retrieved, CARRY OUT a drive test above 15 km/h (9 mph), then REFER to the symptom chart.
Anti-Lock Brake System (ABS) Module Diagnostic Trouble Code (DTC) Index DTCs DTC Caused By Description Action B1342 ABS Module ECU is Defective INSTALL a new ABS module. REFER to Anti-Lock Brake System (ABS) Module in this section. B1484 ABS Module Brake Pedal Input Open Circuit Go To Pinpoint Test D . B1596 ABS Module Service Continuous Codes NOTE: If other DTCs are present, REPAIR them before installing a new component.
TURN the ignition switch to the OFF position and wait at least 30 seconds. Turn the ignition switch to the ON position. REPEAT the ABS self-test. If any DTCs are retrieved, REFER to the Anti-Lock Brake System (ABS) Module Diagnostic Code (DTC) Index. If no DTCs are retrieved, CARRY OUT a drive test above 15 km/h (9 mph), then REFER to the symptom chart. B1676 ABS Module Battery Voltage Out of Range Go To Pinpoint Test E . C1145 ABS Module Speed Wheel Sensor RF Input Circuit Failure Go To Pinpoint Test B . C1155 ABS Module Speed Wheel Sensor LF Input Circuit Failure Go To Pinpoint Test B . C1165 ABS Module Speed Wheel Sensor RR Input Circuit Failure Go To Pinpoint Test B . C1175 ABS Module Speed Wheel Sensor LR Input Circuit Failure Go To Pinpoint Test B . C1222 ABS Module Speed Wheel Mismatch Make sure the tires are the same size and correctly inflated. INSPECT the wheel speed sensor rings. CLEAR the DTC. TEST drive the vehicle. REPEAT the self-test. C1266 ABS Module ABS Valve Power Relay Circuit Failure Go To Pinpoint Test K . C1296 ABS Module Wheel Speed LF Signal Fault Go To Pinpoint Test C . C1297 ABS Module Wheel Speed RF Signal Fault Go To Pinpoint Test C . C1298 ABS Module Wheel Speed RR Signal Fault Go To Pinpoint Test C . C1299 ABS Module Wheel Speed LR Signal Fault Go To Pinpoint Test C . C1300 ABS Module ABS Hydraulic Pump Motor Circuit Failure Go To Pinpoint Test A . C1805 ABS Module Mismatched PCM and ABS Modules Do Not Match CHECK the part numbers. INSTALL the correct module. C2775 ABS Module TC ON/OFF Switch Stuck Failure Go To Pinpoint Test H . U0073 CAN Bus Control Module Communication Bus Off REFER to Section 418-00 . U1900 CAN Bus CAN communication Bus Fault - Receive error REFER to Section 418-00 . U2023 CAN Bus Fault received from External Node REFER to Section 418-00 .

Dodge used an ABS system for 2 years that didn't have a vacuum booster. Instead it used ABS pressure from the pump motor for the power brakes. This is the system you have. The ABS pump is mounted on top of the transmission. Is the pump running when the pedal is hard to push? Sometimes the pressure sensor in the ABS module will go bad and the pump won't run. You will get a hard pedal and the ABS light and the BRAKE lights will be on. The code in the ABS control module will be LOW BRAKE ACCUMULATOR PRESSURE.

C1218 - Pump Motor Circuit Shorted to Voltage or Motor Ground Open
C1243 - BPMV Pump Motor Stalled /These are codes relating to your ABS system(antilock braking). It looks as though you may have a ABS system pump that has burned out. Replace the pump, not the module.

yes yes

This problem sounds like and ABS module that has gone bad, the ABS module has toothed gears inside that actuate the ABS motor, if one of these gears slips a tooth or "unwinds" itself if will not circulate brake fluid to where it needs to go (ex: the rear brakes) alot of times the brake and ABS light will come on, but will not set any trouble codes. My recommendation is to take this to a repair shop and have them verify the problem and replace the ABS module, the motor gears have to be properly aligned when replacing or the lights will stay on and you will still have the same problem. Hope this helps.

THE EBCM IS BAD this is the electronic control module that is on abs pump. you can replace seperate I think it is around 500 for part