Question about 1996 Nissan Maxima
I have a 1996 nissan maxima 5 speed manual....just recently did an engine swap and added a turbo/intercooler system.....a week into driving it my clutch pedal just completely sticks to the floor. I tried bleeding it from on top of engine bay and directly from transmission and it pushed liquid through but the clutch pedal stays soft as can be and sticks to the floor. i am told it is either my slave cylinder or master cylinder....any way to check these to be sure or if it could be something else?
Yes, Briong the pedal up where it belongs, then open an fill your master cylider. Then go below and open the bleeder intil the fluid runs/drips steady and free of any bubbles. Do not pump the pedal. When only fluid comes out, tighten/close the bleeder and give it a try. Good Luck. If peal dives again, replace the master cylinder.
Posted on Jul 11, 2009
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Tips for a great answer:
Sep 20, 2015 | Nissan Maxima Cars & Trucks
Jul 25, 2015 | Nissan Cars & Trucks
Jan 11, 2018 | 2004 Nissan Maxima
Nov 29, 2013 | 1996 Nissan Pickup
Jan 30, 2013 | 1996 Nissan Maxima
Oct 12, 2009 | 1996 Nissan 200SX
Sep 17, 2009 | 1996 Nissan Maxima
930 people viewed this question
Usually answered in minutes!