Question about 1991 Lincoln Town Car

1 Answer

Locatio of inertia switch 1990 lincoln town car

Location of inertia switch 1990 lincoln town car

Posted by on

  • yadayada
    yadayada May 11, 2010

    should be in the trunk.

  • Anonymous Mar 17, 2014

    inertia switch location



1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert whose answer got voted for 500 times.

  • Master
  • 1,129 Answers

Check just above the carpet on the passenger side where your feet go under dash.

Posted on Jul 02, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

Is there a fuel cut off switch on lincoln town car 2003 nd where is it located

On a 2003 Lincoln Town Car, the fuel pump shut off switch ( inertia switch ) is in the trunk , on the drivers side

Oct 09, 2015 | Lincoln Cars & Trucks

1 Answer

How do you disarm/bypass the inertia switch on my 1990 Lincoln Town Car if you don't have the door key??

The inertia switch is bypassed with a jumper wire, but why would you need to do that?

Jun 02, 2015 | Lincoln Cars & Trucks

1 Answer

How do i reset fuel shut off on 96 town car

Locate Inertia Fuel Shutoff Switch--in trunk on left side of rear package tray support and depress reset button (on switch)

Sep 20, 2014 | 1996 Lincoln Town Car

1 Answer

I have a 1995 lincoln town car that will start and run for a secont then shut off, I replaced the computer but is still the same. any ideas?

Try a couple of things. Disconnect the battery terminal for 10 minutes to see if system reboots better. Use the Keypad and enter the Security code on the door before trying to start it.

If it were driveable I would say to go to Autozone or Oreillys for a free scan. If the car does this several times it would not be the Inertia switch.

It would help if you could determine if you are losing spark or fuel to the engine. The only bolt-on part that controls both is the TPS, Throttle Position Switch. It is located on the drivers side of the airhorn behind all the air filter ductwork. It is the size of a cigarette lighter and has 2 screws and 1 electric connection.

Oct 08, 2009 | 1990 Lincoln Town Car

2 Answers


The inertia switch should be located in the trunk, on the right-hand side, behind the feltlike trim material.

Jul 09, 2009 | 1996 Lincoln Town Car

1 Answer

Where is the A/C ACC Temp Sensor located on the 1990 Lincoln Town Car?

sorry i dont have a manual for your car but i have found most of what i need to know on switchs,relays and most all specs by going to good luck on your search hope they can help..

Apr 26, 2009 | 1990 Lincoln Town Car

1 Answer

I need a wiring diagram for a 1990 lincoln town care

fuel pump inside fuel tank accessed by removing plate on forward facing tank panel.
Inertia switch is inside boot/trunk
Ign module is plugged into side of distributor.
The coil is a standard 12 v ignition coil.
The ecm is located projecting through the bulkhead (firewall) by the drivers feet.
You can access the trouble codes with a scanner plugged into the socket in the engine compartment drivers side or by counting flashes of light on a 12v testing light as described in the Haines Manual

Jan 11, 2009 | 1990 Lincoln Town Car

1 Answer

1990 Lincoln TC fuel pump dead

from the ignition switch or the starter, power is taken fromeither of these points to fire the fuel pump on start. This is what charges the fuel system so that you can start. then your fuel pump goes into run mode.

If someone can make a power check on the wiring going to the fuel pump with the engine is being cranked, you can possibly solve your problem.

Nov 17, 2008 | 1989 Lincoln Town Car

Not finding what you are looking for?
1991 Lincoln Town Car Logo

Related Topics:

522 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lincoln Experts


Level 3 Expert

80339 Answers


Level 3 Expert

5687 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Are you a Lincoln Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides