Question about 1999 Hyundai Accent

1 Answer

Engine missing when under load. when cruising runs good. changed fuel filter nohelp.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Hyundai Master
  • 6,674 Answers

When was last tune-up & plug wires done?

Posted on Jul 11, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

U have 1998 s10 2.2. After running good for a few miles the engine starts to bad misfire under a load. If I turn the ignition off and restart the car it runs fine for a few miles then misses again badly...


Do you have a check engine light? If so, go to any auto parts store and have then hook up their OBD2 scanner and have them read the code. Obtaining a code makes it easier for me to diagnose and repair.

Oct 04, 2014 | Cars & Trucks

2 Answers

I have a 2005 Jeep Wrangler Unlimited Straight 6cyl with 6 speed manual transmission. If I sit with the enigne running and the AC for 10 minutes or more the check engine light comes on and the engine cuts...


Chances are there are rust particles in your tank.

you can remove the tank and have it cleaned or just

1.) changes the filter on the fuel pump
2.) change the fuel filter
3.) service the injectors..

but basically i'd recommend you pump the fuel from the tank, take it out and have it cleaned or you can pour liquid lay into it, let it sit over night then was it out with water in the morning and then just let it dry. then you must .

1.) changes the filter on the fuel pump
2.) change the fuel filter
3.) service the injectors..

Jul 29, 2008 | Jeep Wrangler Cars & Trucks

1 Answer

Cylinder misfire


replace no 2 injector

May 05, 2017 | 2009 Chevrolet Traverse

1 Answer

2004 Silverado 4.3 V6 Has miss on cylinders 2 and 4. Have done complete tune up Plugs Wires Cap Rotor,Fuel Filter. Still had Miss. Compression on all 6 within 8 lbs of each other. lowest reading 168...


Check engine light on? Any codes? Missed before and after the cap was changed? Or is the cap new so you assume its good. I have had caps bad out of the box.

May 29, 2011 | Chevrolet C1500 Cars & Trucks

1 Answer

1988 Toyota Camry 2.5 liter V-6. Engine starts fine, but after started it misses. The car misses terribly under a load, but will sometimes accelerate smoothly if you accelerate at a very slow pace. Will...


most misses are injector related either from dirty injectors , low fuel pressure ow injector wiring faults
use a quality injector cleaner for a tank or two
run the fault codes to check for other related sensor problems

May 23, 2017 | 1988 Toyota Camry

1 Answer

My truck has a miss. cutting out real bad on the hwy at higher rate of speed with a load on it especially. I have put new plugs, plug wires, cap and rotor, and air filter on it. the old rotor had an arc...


I would also change the igntition coil if you have not done that already. Have you changed the fuel filter? I would change the fuel filter, if you have a clogged filter thenit may run good at idle and less load conditions but when you call for more fuel during hard excelleration or at highway speeds the engine will not get enough and it will lean fire and buck and miss.

Apr 08, 2010 | 1990 Toyota Pickup

3 Answers

Golf gti mk3 2.0l (2E engine code) is missing !


its a valve sticking or a coil breakdown

Jul 09, 2009 | 1994 Volkswagen Golf

1 Answer

My 98 dodge caravan has a loss of power and dies when stopping


Filter is mounted directly above the pump module on top of the fuel tank. You may have to drop it down a little bit to change it. Also check the fuel pressure with a good gauge while it's running poorly and see if it's out of spec.

Jul 01, 2009 | 1998 Dodge Caravan

2 Answers

Runs good until you accelerate then it lacks power it dont miss just alarge power loss in every gear if you let off of the gas its power comes back its about to drive me crazy please help? dwb


I would suggest changing the fuel filter. The engine seems to be starving for fuel and if the filter is pulgged, the engine will bog down under load. Then the engine will run better when coasting because the fuel pressure will build up again.

Jun 21, 2009 | 2000 Ford Ranger SuperCab

Not finding what you are looking for?
1999 Hyundai Accent Logo

Related Topics:

195 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8202 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...