Question about 2004 Mazda 3

4 Answers

2005 Mazda3. Radio display light died, radio

2005 Mazda3. Radio display light died, radio still works fine.

Posted by on

  • yadayada
    yadayada May 11, 2010

    the radio light display light is a tiny bulb inside the radio, replace it

×

Ad

4 Answers

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

Remove the 15A fuse labeled room clean it and put back. This fixed my 2005 Mazda 3 radio display.

Posted on Jun 06, 2011

Ad
  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 2 Answers
Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 3,854 Answers

If you have the crystal screen that stopped lighting up then your going to have to have it repaired. You can try tapping the screen with your finger  but not to hard and see if you can get it to flicker back on. The heat of the electric current breaks the solder to the Cristal screen and needs to be soldered again. You can remove the radio, but make sure you have the radio code to reactivate it again. Then have the radio repaired at a electronic shop for you, Average repair runs around $75.00 which is better then the price of Dealer replacement. The other food for thought's is the salvage yard, you can most of the time pick one up for around $50.00, just call around first. They all for some reason have different price and if they don't have the radio code you can get it next to nothing. YOu can get the code through www.radio-code.com. Good luck and hope this helps. 

Posted on Jul 02, 2009

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 20 Answers

The LCD (Liquid crystal display) is bad and unfortunately the cost to replace would probably equal the cost or slightly less of a new radio

Posted on Jul 02, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

WHY AREMY RADIO LIGHTS NOT WORK


Could be the radio is just dieing. Could be a bad connection on the plugs on the rear of the radio. Unplug them and reinsert. Check it before you put everything back together.

Nov 20, 2014 | 2005 Chevrolet Silverado

2 Answers

Turn off radio


You should just hold the power button for 3 seconds and it should power off.

Aug 05, 2014 | 2014 Mazda MAZDA3

1 Answer

Hyundai tiburon 2005 factory radio not working? Power issue maybe?


If the radio was on when you jump started car you may have overloaded display, and the radio as a whole may have suffered. You may need to replace the radio. Sorry can't be more help.

May 06, 2017 | 2005 Hyundai Tiburon

1 Answer

The display went out on the radio/cd player of our 2005 Mazda 3. The decorative light works by the volume knob but we cannot tell what station the radio is on or any of the functions because of the lack of...


this happened to me after 2 years of having my 2006 Mazda 3, luckily i was still within warranty. the entire LCD had to be replaced in mine

May 12, 2010 | 2006 Mazda 3

1 Answer

Radio lights, steering wheel radio controls, and HUD not lighting


well, this morning they are fine, all i did was checked all fuses that had to do with illumination and radio. none were bad so no replacements were made, and now it works. wish i knew what i did.

Dec 08, 2009 | 2002 Audi A6

4 Answers

Need a fuse chart


in the owners manual.

Mar 11, 2009 | 2005 Mazda 3

1 Answer

2005 Malibu radio display off and on


the display screen probably overheated since its under warranty take it back and tell them to fix it

Nov 13, 2008 | 2005 Chevrolet Malibu

1 Answer

2005 Sebring Convert Radio/light off


I am having this same problem with my 99 sebring.. anyone know what we can do to fix this?

Oct 21, 2008 | 2005 Chrysler Sebring Conv

1 Answer

2008 mazda3


Start by removing the colored strip which is over the radio display.
(best way is to open the glove box and get underneither it, the right end kind of hooks in at an angle while the left end locks in straight. so work your way to the left first and then the right)

once that is removed, you shuold see four (4) standard screws, remove and save them.
You must remove the top air vent piece, just tip up and pull forward gently.
You will have to disconnect the hazard switch plug also

the stereo set can now be removed by pulling forward gently.
Only two cables are connected to the unit, one can be pulled out, the other must be unclipped.

At this point the WHOLE UNIT including DISPLAY should come out of the console.

On mine, there were directions on how to install and uninstall the CD/MP3 player and if you flip it over you can see where the MINIDisc would go (if you don't have one)

That's it!

Jun 12, 2008 | 2008 Mazda Mazda3 Hatchback

1 Answer

Powerlocks


i shoul not afect any thing unless you replace the batterie with the car runing, and some radios have antitheft code if batterie die or disconect the radio will ask you to type a code in order to work again but most of times it display the worl code on the digital screen

Jun 11, 2008 | 2004 Dodge Neon

Not finding what you are looking for?
2004 Mazda 3 Logo

990 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8547 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...