Question about 2000 Jeep Cherokee

2 Answers

Trouble codes I have a 2000 Jeep Cherokee Sport 4WD I-6 with the check engine light on, checked codes and found the following codes are present...P0441 and P1494. I looked all over and get tons of code definitions and ''replace your gas cap'' statements (already replaced the gas cap and codes are still there) but no other possible fixes, can anyone out there give me any idea of what part to replace to fix this? Thank you. -Nathan

Posted by on

  • Boris Klemoff
    Boris Klemoff Oct 25, 2013

    Try the BWD Vapor Canister Purge Solenoid it"s on the firewall I have a 1997 and that's what it was



2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.


    An expert that got 20 achievements.


    An expert that got 10 achievements.

  • Jeep Master
  • 81,400 Answers

Evaporative Emission System Incorrect Purge Flow
Jeep: Leak detection pump pressure switch or mechanical fault
U either have a leaking fuel system or the pressure sensor at the gas tank is defective, I would replace the pressure sensor 1st.

Posted on Jul 02, 2009

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

For a short term fix you can run a bottle of gas treatment therw it. The light will go off for a while. Most of the time it is a small leak in a line the size of a pen hole above the gas tank. Hard to get to and costley to fix. Hope I helped!! Maggie

Posted on Jul 30, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How to fix 1999 jeep cherokee sport

You mean it cranks but does not start, right ?
The NoBus on the display means the cluster is not talking to the computer. That could be a wiring problem or a component problem.
Have you checked the engine computer for trouble codes ?

Jul 27, 2014 | Jeep Cherokee Cars & Trucks

1 Answer

Same the above with my 2000 cherokee sport 6 cyl. Check engine light came on and motor vibrated and ran ROUGH, I checked the exhaust for smoke, oil for anti freeze, both negative. Light started flashing so...

all are very possible but you can go to any chain auto parts to get your codes read especially if your light was flashing this indicates serious trouble once you have the codes its easier to help you but it sounds like a misfire to me meaning bad spark plug,wire or coil.

Dec 01, 2010 | 2001 Jeep Cherokee

1 Answer

1998 Jeep Cherokee Sport w/ 4 liter in-line 6, I have a check engine light on and the hand held diagnotic unit is telling me "BANK 1 SENSOR 1 HIGH VOLTAGE". What is the cause(s)?

Your O2 sensor needs to be replaced. These sensors constantly out put voltage from .1 volts up to 1.3 volts, your sensor is stuck in the high range. It is the first O2 closest to the engine.

Sep 08, 2010 | 1998 Jeep Cherokee 4WD

1 Answer

2000 jeep cherokee sport...can I check the engine codes by cycling ignition switch?

if so just turn the key to run position ( not start) then one click back. Do this a total of 3 times ending in the run ( or on; not start) position. The odometer will display the code(s) or in an older model the check engine light will flash out the code. Have your pen and paper ready to jot down the results.

Aug 23, 2010 | 2000 Jeep Grand Cherokee

1 Answer

Engine trouble light coming on 2003 jeep gr. cherokee

If the light is ywllow, it's emmissions or some sensor. You can drive to a service center and have the codes read. If the light is red...STOP!! and check engine oil. DO NOT drive further!! Have it towed in for service.

Dec 30, 2009 | 2003 Jeep Grand Cherokee

1 Answer

How can i easily trouble shoot rear defrost problems for 2000 jeep cherokee sport ( it isnt working at this time)

Use a test light and see if you get current to the grid. Check it on the sides. If no current check the switch and fuse.

Dec 20, 2009 | 2000 Jeep Cherokee

1 Answer

All of the gauges on my 98 Cherokee Sport quit

you probably got your alternator wet. take it to your local auto parts store and have them check it

Dec 14, 2009 | 1998 Jeep Cherokee

1 Answer

2000 Jeep Cherokee Sport 4.0l

Find out what the code is from the check engine light. Autozone will usually read them for free.

Apr 14, 2009 | 2000 Jeep Cherokee

1 Answer

Turn signal sometimes flashes both rear turning lights

I would check the flasher due to the fact that is where power is being sent to to send out intermit voltage to the rear lamps. check for open or groundin wires

Dec 10, 2008 | 2000 Jeep Grand Cherokee

2 Answers

Engine light

you can't you need a scan tool. sorry buddy good luck

Oct 19, 2008 | 2000 Jeep Cherokee

Not finding what you are looking for?
2000 Jeep Cherokee Logo

893 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts


Level 3 Expert

81400 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides