Question about 1993 Honda Accord

2 Answers

93 honda accord, 10th anniversary edition. The Check engine lightcame ON and after some research, I found out that it is the Exhaust Recirculation System. What the heck is this? How long can I go without repairing it and how much is it going to cost me to repair it? Please help. Thank you.

Posted by on

  • nikunjd05 Jul 02, 2009

    Thank you Scott.
    I dont know much about cars and dont even know where the EGR is. So I will porbably have it looked by a mechanic and see if he can clean it out.

×

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 50 Answers

Hi there. This is normally called the EGR (Exhaust Gas Recirculation) and without going into detail it is used to improve vehicle emissions. It’s basically a large value which is operated by manifold vacuum, its opening is controlled electronically and there are four possible problems, the vacuum system is not operating correctly, there might be an electrical problem, a seized EGR value or the internal filter is blocked. Firstly, I’d check all the vacuum connections (simply follow them through from one end to the other), you can strip the EGR valve down, clean the filter and check the valve is not seized. Of course, it’s always better that the EGR is working as it should and you should have it repaired by an experienced Tuning Shop or Dealer. Hope this helps, Scottech.

Posted on Jul 02, 2009

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 101 Answers

Not a foreign car guy...but.. from what i understand, that exhaust stuff is suppose to help draw unburnt gasses and stuff from ur exhaust to reuse. logically.. there shouldnt be any problem if u dont ever get it fixed.. I could be totally wrong, but hey, its an idea

Posted on Jul 02, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Fire going to core pack but no spark from plug will not start


if power going to the coil and not coming out you may have a bad coil is it getting fuel?now if you have a v6 engine try swooping coils with one that works if it work on the cylinder then you know you have to replace that coil

Dec 17, 2015 | Honda Cars & Trucks

1 Answer

1993 Honda accord 10th anniversary edition won't start, turns over, has spark & fuel pressure. 2.2 motor auto transmission.


These have a know issue with the Distributors.. You may be seeing a spark but the spark may be so weak that it is not sufficient to ignite the air/fuel mixture in a compressed environment.

I had this happen to my 1992 Honda. Cost me over $400 in Troubleshooting and nobody could figure it out. I went to one of my venders (Parts for Imports) and they enlightened me and sold me a New Distributor and installed it and BAM!!!! Ran like a top.

I did extensive Troubleshooting myself, ran into a brick wall because mine was doing the same... Good Fuel Pressure, Spark but Nothing.

One thing does come to mind that I tested mine and that is to do a Compression Test or pop the cover off the Timing Belt to see if it is Moving or if the Timing has jumped...

This Motor is an INTERFERENCE MOTOR, If the Belt Broke or Slipped, you could have caused some damage.

If you need any further assistance, please let me know. I have an extensive Background with Honda's... I certified as an ASE Mechanic in 1979 (Dang I am getting OLD)....

Apr 04, 2013 | Cars & Trucks

1 Answer

How long should it take me to replace the fuel filter on my 1993 HONDA ACCORD 10TH YEAR ANNIVERSARY EDITION


Its located underneath the drivers side door, about a foot towards the center of the car. depending on the tools you use, and how rusted the bolts are, and your expirience, expect to be working on it about 45 mins to and hour.

Sep 17, 2011 | 1993 Honda Accord

1 Answer

I have a 1993 honda accord 10th anniversary edition, ok when i turn on the a/c the green light comes on and the compressor kicks on you can feel a change in the drive and the clutch engages i seen it...


Then your vent control is not working, since this is a 1993 you would be able to see the filter drier ice up on the enternal area.Also make sure the heater control cable is not engage

Jun 04, 2011 | 1993 Honda Accord

1 Answer

RPM's are jumping around at high speeds


Sounds like you may have a bad ground somewhere or a bad power connection.

Sep 14, 2009 | 1993 Honda Accord

1 Answer

Low idol speed


have someone hook up with better scan tool that reads more than code 6

Aug 24, 2009 | 1993 Honda Accord

1 Answer

1993 Honda Accord missing drivers side exterior door lock


Contrary to what the previous poster said, you do not need to involve the dealer on this. Go to a junk yard and get a lock assembl, then take the car and the lock to a locksmith and he can rekey it to match the car's key and install it for you. might cost $100 total...
hope this helps...;-)

Apr 14, 2009 | 1993 Honda Accord

1 Answer

1993 Honda Accord car jerks forward when placed drive (D4)


look carefully at the front engine mount and the rear engine mount...the front dogbone looking mount usually crack or break ...ur rear mount may also be broken and or worn...

Apr 11, 2009 | 1993 Honda Accord

Not finding what you are looking for?
1993 Honda Accord Logo

296 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...