Question about 2005 Ford Escape

1 Answer

My 2005 ford escape will not start... problem codes were pertaining to coils a-f failure and misfire 1st 1000 rpm and misfire #4 - cleared codes, will turn over but will not fire off of gumout in the intake or cylinder and am reading voltage from the wires to one of the coil packs

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert whose answer got voted for 2 times.

  • Contributor
  • 2 Answers

Swap the coil pack with another cylender. If the error code follows the coil pack then replace the coilpack.

Posted on Jul 15, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2005 ford escape 3.0L misfire

That is an ignition coil malfunction on the primary side.

Jul 16, 2017 | 2005 Ford Escape

1 Answer

I have a 2003 ford escape v6 every time it is wet outside or damp it has a misfire and a code for idle under 1000 rpm what could be the problem

Ignition system faulty, most probaby the coil, or igniton module, I would also check your distrubuter cap if so equipped.

Dec 09, 2013 | Cars & Trucks

1 Answer

Error code po 303 316 354 355 356

P0303 Cylinder 3 Misfire Detected
P0316 Engine Misfire Detected on Startup (First 1000 Revolutions)
P0354 Ignition Coil "D" Primary/Secondary Circuit
P0355 P0356 Ignition Coil "F" Primary/Secondary Circuit
Hope them can help you!
Multi-Diag Access J2534

Apr 15, 2013 | 2005 Ford Escape

1 Answer

2005 Mazda Tribute P0172 & P2270

Hi Paul, Have you had a fault code relating to the knock sensor? That sensor controls ignition timing which can have a relationship to the fault codes you report? Regards John

Apr 06, 2013 | 2005 Mazda Tribute

1 Answer

I have a 2003 ford escape. It runs rough when i start it or when im idling and on inclines. When i had the check engine light read (again) it said random misfire, misfire in the first 1000 rpm and misfire...

Remove the intake manifold, if necessary & change
the other 3 plugs & coils,assuming a V6, if not then the
codes were wrong & you did the wrong coils

No code tells you what to replace,only component testing does

Most likely been in there for 10 years

Replace the front O2 Sensors--their only good to 100,000 miles
Leave the rear monitors in converter outlet

Don't waste your money on putting something in the fuel tank
That is never a repair & is diluted 12 or 16 oz to 15 gallons
of fuel That alone tells you it is useless

Probably pay the replace the EGR Valve if not done already

They don't last a few years on a ford

Sep 16, 2012 | Cars & Trucks

1 Answer

2001 Escape 3.0 L "suddenly"

go to autozone for a free code readout.

I suspect you are going to get misfire codes. You need to fix ASAP as misfire will ruin your cats which are part of teh manifolds which means abotu $1000 for both.
I think you are going to have to replace all plugs and COPS, coils on plugs. Or at least on the misfring cylinders.

The danger here also is that a shorted COP will take out your PCM, engine computer.

Report back codes and progress.

Nov 24, 2010 | 2001 Ford Escape

2 Answers

Does anyone know what the code po316 is on the ford escape v6? there is also po300b,po303,po304b,po357and po353 codes

P0316 .... Engine Misfire Detected on Start-up (first 1000 Revolutions)

P0300b .. Random/Multiple Cylinder Misfire Detected

P0304b .. Cylinder 4 Misfire Detected

P0357 .. Ignition Coil G Primary/Secondary Circuit

P0353 .. Ignition Coil C Primary/Secondary Circuit

From codes you need new spark plus, Ignition Wires, and ignition coils

Feb 07, 2010 | 2005 Ford Escape

Not finding what you are looking for?
2005 Ford Escape Logo

Related Topics:

468 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

81294 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

gerry bissi

Level 3 Expert

4376 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides