Question about 1995 Chrysler Cirrus

1 Answer

My tcm needs to be programmed for 1995 cirrus

I have a 1995 cirrus. I replaced the tcm but it still slips. I was told it had to be programmed. Can do it,or does it take some kind of machine or computer?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Chrysler Master
  • 412 Answers

THE PINION FACTOR OR TIRE SIZE,MUST BE PROGRAMMED WITH A SCAN TOOL IF YOU INSTALLED A NEW TCM..IF TRANS IS SLIPPING..THERE SHOULD BE A FAULT CODE IN TCM

Posted on Jul 05, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1995 chrysler cirrus over heating and water not circulating? was told it was the thermostat


it could also be the water pump not pumping water thru the engine i have seen that myself alot

Jun 25, 2012 | 1995 Chrysler Cirrus

2 Answers

Code p0734 I just replaced eng. and trans. now have this code.


Engine Light ON (or Service Engine Soon Warning Light)
- Incorrect transmission shifting Possible causes - Low transmission fluid level
- Dirty transmission fluid
- Shift solenoids
- Transmission mechanical problems
- Transmission hydraulic control circuit Tech notes Start by inspecting the transmission fluid level and condition, and change fluid if necessary. When is the code detected? P0734 is detected when A/T cannot be shifted to the 4th gear position even if electrical circuit is good. P0734 NISSAN Description This diagnosis monitors actual gear position by checking the torque converter slip ratio calculated by Transmission Control Module (TCM) as follows:

Torque converter slip ratio = A x C/B

A: Output shaft revolution signal from revolution sensor
B: Engine speed signal from Engine Control Module (ECM)
C: Gear ratio determined as gear position which TCM supposes

If the actual gear position is higher than the position (4th) supposed by TCM, the slip ratio will be more than normal. In case the ratio exceeds the specified value, TCM judges this diagnosis malfunction.

Aug 09, 2011 | 1995 Nissan Altima

1 Answer

I have a 1998 Chrysler Cirrus. My car was acting up and the check engine light came on. I took it to autozone and they gave me these codes. P0700 and P0725. I was told that the speed sensor is at fault. Is...


code p 0700 is then TCM( transmission control module code p 0725 is the engine rpm input--circuit malfunction=== causes --wiring--CKP (Crank position )/ rpm sensor--ECM ---TCM--
depending on how your car is acting up will depend on if it is the TCM or the crank position sensor

Feb 27, 2018 | 1999 Chrysler LHS

1 Answer

How to replace fuel pump on 95 chrysler cirrus.Need detailed instructions on how to remove and replace fuel pump module on 1995 Chrysler cirrus.


to detailed to explain here. buy a hanynes repair manual at local auto store, 17$ it'll explain step by step.

Jul 01, 2009 | 1995 Chrysler Cirrus

1 Answer

I have a 1995 Chrysler Cirrus LX and it won't shift above 2nd


Sounds like your original problem was the TCM. Find out what codes are in the TCM, and fix them. You most likely have a bad output or input speed sensor, or a solenoid pack.

Jun 19, 2009 | 1995 Chrysler Cirrus

1 Answer

92 Honda Accord LX auto Trans


Normally when u have a TCM problem, what the car do is hard to change gear, but if your is slipping you will have to do something to you transmission, replace or rebuilt it, good look

Nov 01, 2008 | 1992 Honda Accord

Not finding what you are looking for?
1995 Chrysler Cirrus Logo

Related Topics:

286 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

chargerhp
chargerhp

Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...